Nissens 891038 A/C Compressor

Nissens A/C Compressor for BMW X2

The Nissens 891038 A/C compressor is built to OE standards for stable cooling performance in demanding HVAC systems. It is engineered with critical components such as the pulley, clutch, hub, bearing, and wobble plate designed to reduce noise and vibration while maintaining consistent pumping efficiency.

Compatible with 2019-2024 BMW X2 applications, this compressor is a direct-fit HVAC replacement for vehicles using R134A or R1234YF refrigerant and PAG 46 YF oil.

Key Features

• OE-standard compressor construction for BMW X2 HVAC systems
• Part number 891038 for direct identification and ordering
• Supports R134A and R1234YF refrigerant types
• Pre-filled with oil for service preparation
• 6-groove serpentine pulley design
• Includes clutch, O-rings, and 2-pin connector configuration
• 6VS14e compressor type for specified vehicle applications

Detailed Description

Nissens 891038 is an A/C compressor designed for 2019-2024 BMW X2 models. The compressor is manufactured to OE-level standards and uses a refined internal design to support smooth operation, low noise, and reduced vibration under high-load conditions. Its 4.53-inch outside pulley diameter, 6-groove serpentine belt interface, and clutch-included configuration make it a practical replacement for service work on the BMW X2 air conditioning system.

This part cross-references Monroe Shocks & Struts (e.g., ACP600000P, ACP600000S) for the same application. The part number 891038 is also useful when verifying interchange references during compressor replacement or HVAC diagnostics.

Common Problems This Part Can Address

• Weak or inconsistent cabin cooling
• Compressor noise, vibration, or pulley-related operation issues
• Loss of refrigerant system pressure from compressor wear
• HVAC performance decline in BMW X2 models
• Failure of the original A/C compressor clutch or internal pumping components

Installation Notes and Tips

Fits 2019-2024 BMW X2, N/A. Compressor filled with shipping oil only, must drain and refill. Verify refrigerant type, oil specification, connector pin count, and pulley configuration before installation. Replace system O-rings as needed and follow proper evacuation, recharge, and leak-check procedures after compressor service.

Quality Assurance

Nissens manufactures this compressor to OE standards and test-proves it for high-stress operating conditions. The design focus on the pulley, clutch, hub, bearing, and wobble plate supports durable operation and consistent A/C performance in BMW X2 applications.