Nissens 891661 A/C Compressor

Nissens A/C Compressor for Honda Fit

The Nissens 891661 A/C compressor is built to OE standards for dependable cabin cooling in the 2009-2013 Honda Fit. It is engineered for stable pumping performance, low noise, and reduced vibration in demanding HVAC service.

• OE-standard compressor construction from Nissens
• TRSE07 compressor type with 12V operation
• R134A refrigerant and PAG 46 oil specification
• Clutch included for direct compressor replacement
• Serpentine belt pulley with 5 grooves
• 3-pin electrical connector
• O-rings included; oil filled
• Outside pulley diameter: 4.375 in.

Detailed Product Overview

Part number 891661 is a Nissens A/C compressor designed for the HVAC system in the 2009-2013 Honda Fit. Nissens focuses on critical compressor components such as the pulley, clutch, hub, bearing, and wobble plate to support consistent refrigerant flow, quiet operation, and long service life. This unit cross-references UAC CO11312C for the same application.

Fitment

• Fits 2009-2013 Honda Fit, N/A.

Common Problems This Part Can Address

• Weak or inconsistent air conditioning output
• Compressor noise, vibration, or pulley-related wear
• Loss of refrigerant circulation in the HVAC system
• Clutch engagement issues affecting compressor operation
• Cooling performance decline in the Honda Fit A/C system

Installation Notes and Tips

Before installation, drain the shipping oil and refill with the correct amount and type of PAG 46 oil for the vehicle application. Verify R134A system compatibility, inspect the belt drive and electrical connector, and replace the included O-rings during installation. Proper evacuation and recharge procedures are required after compressor replacement.

Quality Assurance

Nissens manufactures this compressor to OE-level standards and tests it for performance under high-stress operating conditions. The design emphasis on key rotating and pumping components supports consistent fit and function in the Honda Fit HVAC system.