Nissens 891680 A/C Compressor

OE-Style A/C Compressor

The Nissens 891680 A/C compressor is built to OE standards for reliable refrigerant circulation and stable performance under demanding operating conditions. It is a fitment-based replacement for select Hyundai Palisade applications and uses a DVE16 compressor design with a serpentine pulley setup.

Compatible With 2023-2025 Hyundai Palisade, N/A. The 891680 part number is a direct reference for buyers searching for the correct compressor for this application.

• OE-standard construction for consistent compressor operation
• DVE16 compressor type with 6-groove serpentine pulley
• Clutch included for a complete compressor assembly
• Configured for R134A and R1234YF refrigerant systems
• 12-volt electrical setup with 3-pin connector
• O-rings included for sealing at installation points

Detailed Product Overview

Nissens 891680 is engineered around the compressor’s critical moving parts, including the pulley, clutch, hub, bearing, and wobble plate, to support smooth pumping action with reduced noise and vibration. The unit is specified with oil filled status, a 4.33-inch outside pulley diameter, and two included O-rings, making it a practical replacement for HVAC service on the Hyundai Palisade. If you are sourcing an A/C compressor for a 2023-2025 Hyundai Palisade, 891680 is the part number to verify against the vehicle’s refrigerant and connector requirements.

This part cross-references Hyundai 97701S8600 for the same application.

Common Problems This Part Addresses

• Loss of cabin cooling from compressor wear or internal failure
• Excessive compressor noise or vibration during A/C operation
• Refrigerant circulation issues caused by damaged clutch or pulley components
• Electrical connection mismatch when replacing the original compressor
• Seal leakage at compressor service points

Installation Notes and Tips

Verify refrigerant type, connector pin count, pulley configuration, and compressor type before installation. This application note states that the compressor is filled with shipping oil only and must be drained and refilled during service. Replace and evacuate the system according to standard HVAC procedures, and confirm all sealing surfaces are clean before fitting the included O-rings.

Quality Assurance

Nissens manufactures compressors to OE standards and tests them for performance under high-stress conditions. The design focus on the pulley, clutch, hub, bearing, and wobble plate supports durability, low noise, and stable pumping performance.