Nissens 891717 A/C Compressor

OE-Standard A/C Compressor

This Nissens A/C compressor is built to OE standards for reliable refrigerant circulation and stable cabin cooling performance. It fits Kia Forte and Kia Forte5 applications with the specified compressor configuration, and part number 891717 is a direct reference for ordering and verification.

Key Features

• OE-standard compressor construction from Nissens.
• VS14E compressor type with 12-volt operation.
• Compatible with R134A and R1234YF refrigerant systems.
• Oil-filled unit with clutch included.
• 6-groove serpentine pulley for belt-driven operation.
• Includes 2 O-rings for sealing points.

Detailed Description

Nissens part number 891717 is an A/C compressor engineered for OE-level performance in modern HVAC systems. The compressor uses a VS14E design with a 4.5-inch pulley, 6 pulley grooves, a 3-pin connector, and a clutch assembly to support consistent engagement and efficient pumping. Nissens also focuses on the critical internal and rotating components, including the pulley, clutch, hub, bearing, and wobble plate, to reduce noise and vibration while maintaining durability under demanding operating conditions. This part cross-references Monroe Shocks & Struts (e.g., 97701M7000, CO11598C) for the same application.

Fits 2019-2024 Kia Forte, N/A. Fits 2020-2021 Kia Forte5, N/A. For these applications, the compressor is listed as filled with shipping oil only and must be drained and refilled before installation. Verify refrigerant type, connector style, and pulley configuration before ordering. Part number 891717 is also useful when matching the compressor to the correct Kia Forte or Kia Forte5 HVAC setup.

What It Is Used For

• Restoring refrigerant compression in a weak or failed A/C system.
• Replacing a compressor with clutch wear, bearing noise, or poor engagement.
• Addressing cooling loss caused by internal compressor inefficiency.
• Correcting belt-drive issues tied to pulley or hub wear.

Installation Notes and Tips

Drain the shipping oil and refill with the correct oil specification before installation. Confirm the refrigerant system uses R134A or R1234YF, and match the 3-pin connector, 6-groove serpentine belt drive, and pulley dimensions to the original unit. Replace and lubricate sealing points as needed, and evacuate and recharge the system according to service procedures.

Quality Assurance

Nissens manufactures compressors to OE standards and tests them for performance under high-stress operating conditions. The design targets low noise, reduced vibration, and durable operation through attention to the pulley, clutch, hub, bearing, and wobble plate.