Nissens 89496 A/C Compressor

Nissens 89496 A/C Compressor for Range Rover

The Nissens 89496 A/C compressor is a direct-fit HVAC replacement for select Land Rover Range Rover applications. It is built for R134A systems and comes pre-filled with PAG 46 oil for a faster, cleaner installation on the correct vehicle.

Key Features

• Part number 89496 A/C compressor for select Land Rover Range Rover models
• PXV16 compressor type for the specified HVAC system
• Designed for R134A refrigerant
• Uses PAG 46 compressor oil
• 6-groove pulley configuration
• Maximum pulley diameter: 4.3307 in.
• FIRST FIT application with pre-filled PAG oil and O-rings when needed
• Cross-references Four Seasons 97570 and 98570 for the same application

Detailed Description

Nissens 89496 is an A/C compressor engineered for 2006-2009 Land Rover Range Rover vehicles with the listed fitment. It is a PXV16 compressor built for R134A refrigerant systems and supplied with pre-filled PAG 46 oil, helping streamline replacement on the correct Range Rover HVAC setup. The FIRST FIT format is intended to reduce prep time during installation, and the part number 89496 is also referenced by other aftermarket listings for the same application.

Nissens develops thermal management components with a focus on consistent manufacturing quality and ongoing aftermarket coverage. For buyers searching for a 2006 Land Rover Range Rover A/C compressor, a 2007 Range Rover compressor from chassis/VIN 7A253531, or a 2008-2009 Land Rover Range Rover HVAC compressor, this unit matches the confirmed vehicle data below.

What It Helps Address

• Weak or inoperative cabin cooling
• Compressor noise from internal wear or failure
• Loss of refrigerant circulation in the A/C system
• Incorrect compressor type during Range Rover HVAC repair
• Service delays when replacing a failed 89496 compressor

Installation Notes and Tips

Verify refrigerant type, oil specification, pulley groove count, and compressor type before installation. This compressor is listed for R134A systems with PAG 46 oil and a 6-groove pulley. Confirm chassis/VIN break information for 2007 Range Rover applications: from chassis/VIN 7A253531 or to chassis/VIN 7A253530, depending on build date. Always evacuate and recharge the system according to the vehicle service procedure after compressor replacement.

Quality Assurance

Nissens positions this part within its Genuine Nissens Quality standard, reflecting the company’s manufacturing focus on thermal and engine efficiency components. Part number 89496 is supported by confirmed fitment data for select Land Rover Range Rover vehicles and by cross-reference listings for the same application.