Nugeon 97-01506A Disc Brake Caliper - Front Right

Front Right Reman Brake Caliper for Toyota

Nugeon 97-01506A is a remanufactured disc brake caliper for the front right position on select Toyota applications. It is built with a cast iron housing, steel pistons, dust boots, and rust preventative finish for service-ready brake system replacement.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured hydraulic brake components with application-specific hardware details. For this part, the caliper includes a bleeder screw and brake pad installation hardware with banjo bolt and copper crush washers where applicable.

Key Features

• Remanufactured disc brake caliper for front right installation
• Fits 1979-1983 Toyota Pickup, front right, exc 1 ton
• Fits 1974-1982 Toyota Corona, front right
• Fits 1978-1980 Toyota Cressida, front right
• Fits 1975-1978 Toyota Pickup, front right
• Cast iron housing with rust preventative finish
• Steel pistons with 54 mm outside diameter
• Dust boots included
• Bleeder screw included, M10-1.0 x 32 thread
• Inlet fitting uses M10-1.0 tube seat connection

Detailed Description

Nugeon 97-01506A is a reman brake caliper engineered for Toyota front right brake service on Pickup, Corona, and Cressida models listed in the fitment data. It uses a cast iron body with two steel pistons and a rust preventative finish to replace a worn or sticking caliper in the hydraulic disc brake system. The caliper is supplied in grey and includes dust boots and a bleeder screw for brake bleeding during installation.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Fix

• Uneven front brake pad wear on the right side
• Brake drag caused by a sticking caliper piston
• Soft or inconsistent braking from caliper hydraulic leakage
• Bleeding issues after brake hydraulic service
• Corrosion-related caliper replacement on older Toyota brake systems

Installation Notes and Tips

Verify the front right position, inlet thread size, and bleeder screw thread before installation. Transfer or install the brake pad hardware and banjo bolt components only where applicable to your vehicle setup, and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm rotor condition, pad thickness, and hose condition before returning the vehicle to service.

Quality Assurance

This remanufactured caliper is built for direct replacement use on the listed Toyota applications and is supplied with key service components such as dust boots and a bleeder screw. Confirm fitment against the vehicle year, model, and front right position before ordering.