Nugeon 97-02715A Disc Brake Caliper - Front Right

Front Right Reman Caliper for Mercedes-Benz 560SL

Nugeon 97-02715A is a remanufactured front right disc brake caliper for 1986-1989 Mercedes-Benz 560SL models with the ATE design. It is built with a cast iron housing, grey rust-preventative finish, and a steel piston assembly for brake system service on the front right corner.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics with application-specific fitment and service-ready components. For this Mercedes-Benz 560SL front right caliper, the design includes a bleeder screw, dust boots, and brake pad installation hardware where applicable, along with a banjo bolt and copper crush washers where applicable.

• Fits 1986-1989 Mercedes-Benz 560SL, front right
• Remanufactured disc brake caliper for brake hydraulic replacement
• ATE design for the specified application
• Cast iron housing with rust-preventative finish
• Grey caliper color with dust boots included
• Bleeder screw included with M8-1.25 thread
• M10-1.0 inlet port thread size
• Steel piston construction with 40 mm piston diameter
• Brake pad installation hardware included where applicable

This Nugeon 97-02715A caliper is used to restore hydraulic clamping force at the front right wheel on Mercedes-Benz 560SL models. It is a direct service part for replacing a worn, sticking, leaking, or corroded caliper on the 1986-1989 Mercedes-Benz 560SL, front right. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Service Issues

• Brake fluid leakage from a damaged caliper body or seal area
• Uneven braking caused by a sticking piston or seized caliper
• Poor pedal response from internal hydraulic wear
• Corrosion on the original front right caliper housing
• Brake drag or pad wear irregularities at the front wheel

Installation Notes and Tips

Verify the vehicle uses the ATE design and confirm the front right position before installation. Inspect the brake hose, banjo bolt sealing surfaces, and copper crush washers during service, and bleed the hydraulic system after installation to remove air from the circuit. Confirm inlet thread size M10-1.0 and bleeder thread size M8-1.25 during fitment checks.

Quality Assurance

This remanufactured caliper is built for the specified Mercedes-Benz 560SL brake application and finished with rust prevention to support service life in brake system use. Nugeon reman brake hydraulics are rebuilt for application-specific replacement needs, and part number 97-02715A identifies the correct front right caliper for the listed vehicles.