Nugeon 97-07614B Disc Brake Caliper - Front Right

Nugeon 97-07614B Front Right Disc Brake Caliper

Nugeon 97-07614B is a remanufactured front right disc brake caliper for select Dodge and Plymouth applications. It is built with a cast iron housing, grey rust-preventative finish, and a steel piston to support consistent hydraulic braking performance.

This Reman Caliper w/ Installation Hardware product line focuses on replacement calipers prepared for direct brake service work, with the key wear components and service features needed for a front right brake repair on the listed vehicles.

Key Features

• Remanufactured disc brake caliper for the front right position
• Cast iron housing with grey rust-preventative finish
• Steel piston with 2-inch (48 mm) outside diameter
• Bleeder screw included; banjo bolt inlet fitting
• Dust boots included for caliper sealing protection
• Brake pad installation hardware included where applicable
• Housing cast number 903-13
• Part number 97-07614B

Detailed Description

Nugeon 97-07614B is a remanufactured front right disc brake caliper engineered for 1978 Dodge Charger, 1980-1982 Plymouth TC3, and 1982 Dodge Rampage applications. It uses a single steel piston and a banjo bolt inlet connection with a 7/16-20 inlet thread size, making it a direct-service replacement for the specified brake hydraulics setup. The grey finish and rust-preventative coating help protect the cast iron body during normal service conditions, while the included dust boots and bleeder screw support brake system maintenance.

For shoppers searching for a front right brake caliper for 1982 Dodge Rampage, a remanufactured caliper for 1980-1982 Plymouth TC3, or a replacement disc brake caliper for 1978 Dodge Charger, part number 97-07614B provides the listed fitment and hardware details in one service part.

What This Caliper Helps Address

• Brake fluid leakage at the caliper body or piston seal area
• Uneven front brake performance on the right side
• Sticking or seized caliper piston operation
• Corrosion on an original front brake caliper housing
• Service needs during front brake repair or restoration work

Installation Notes and Tips

• Fits 1982 Dodge Rampage, front right.
• Fits 1980-1982 Plymouth TC3, front right.
• Fits 1978 Dodge Charger, front right.
• Verify the banjo bolt inlet connection and 7/16-20 inlet thread size before installation.
• Inspect brake hoses, pads, and mounting surfaces during caliper replacement.
• Bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

This remanufactured caliper is prepared as a service replacement brake hydraulics component with a rust-preventative finish, dust boots, and included bleeder screw. Part number 97-07614B is built for the listed Dodge and Plymouth front right applications and is identified by housing cast number 903-13.