Nugeon 97-17255B Disc Brake Caliper - Rear Right

Rear Right Reman Brake Caliper for Pontiac

Nugeon 97-17255B is a remanufactured disc brake caliper for the rear right position on select Pontiac applications. It is built with an aluminum housing, a single 48 mm steel piston, and a rust preventative finish for service-ready brake system replacement.

This reman caliper w/ installation hardware line focuses on practical brake service details, including a bleeder screw, dust boots, and the required brake pad installation hardware package noted in the product contents. Compatible With 1984-1988 Pontiac 6000, rear right, and 1984-1987 Pontiac Fiero, rear right.

Key Features

• Remanufactured disc brake caliper for rear right brake service
• Aluminum caliper housing with grey rust preventative finish
• Single 48 mm steel piston for hydraulic actuation
• Bleeder screw included with M10-1.5 thread
• Dust boots included
• Banjo bolt inlet fitting with M10-1.5 inlet port thread
• Housing cast numbers: 298-3, A-50
• Part number: 97-17255B

Detailed Description

Nugeon 97-17255B is a remanufactured rear right disc brake caliper engineered for Pontiac 6000 and Pontiac Fiero rear brake applications. The aluminum casting helps keep the assembly lightweight, while the steel piston and included dust boots support dependable caliper operation in everyday braking service. The caliper is finished with a rust preventative coating and includes a bleeder screw for brake bleeding during installation. The inlet uses a banjo bolt connection with M10-1.5 thread sizing, and the unit is identified by housing cast numbers 298-3 and A-50. If you are replacing a worn or sticking rear caliper on a Pontiac 6000 or Pontiac Fiero, 97-17255B provides the correct rear right configuration for the listed vehicles.

What This Caliper Helps Address

• Uneven rear braking from a sticking caliper piston
• Brake fluid leakage at the caliper body or bleeder area
• Brake drag caused by worn internal seals or damaged dust boots
• Poor pedal response from a failing rear hydraulic caliper
• Brake service needs on a rear right Pontiac 6000 or Pontiac Fiero

Installation Notes and Tips

Verify rear right placement, inlet thread size, and banjo bolt connection before installation. Bleed the brake system after installation and inspect copper crush washers and brake line sealing surfaces as required by the vehicle setup. Confirm pad hardware transfer or replacement needs during brake service, since pads are not included with this caliper. Part number 97-17255B should be matched to the listed fitment before assembly.

Quality Assurance

This remanufactured caliper is supplied by Nugeon as a brake hydraulics replacement part for the specified Pontiac applications. The product includes the listed service components and is built to match the rear right fitment requirements for 1984-1988 Pontiac 6000 and 1984-1987 Pontiac Fiero.