Nugeon 97-17626B Disc Brake Caliper - Front Right

Nugeon Reman Caliper w/ Installation Hardware

Nugeon 97-17626B is a remanufactured disc brake caliper built for brake hydraulic service where a direct replacement caliper is needed. It features a cast iron housing, grey rust-preventative finish, steel pistons, and dust boots for a service-ready brake repair.

The Reman Caliper w/ Installation Hardware product line focuses on practical replacement parts for brake system maintenance. This caliper includes the brake pad installation hardware package with banjo bolt and copper crush washers where applicable, helping streamline a brake caliper replacement on supported applications.

• Remanufactured disc brake caliper for brake hydraulic repair
• Cast iron housing with grey rust-preventative finish
• Steel pistons with dust boots included
• Bleeder screw included; bleeder screw size 3/8-24 x 1
• Inlet fitting type: plug; inlet thread size 7/16-20
• Housing cast numbers: KH91133, 1535
• Nugeon 97-17626B for brake caliper replacement service

This Nugeon caliper is built with two 60 mm steel pistons and is intended for disc brake hydraulic applications that require a remanufactured caliper assembly. The grey finish and rust-preventative coating support long-term service use, while the included bleeder screw and dust boots address common wear items found during caliper replacement. If you are sourcing a brake caliper for a Honda Civic or similar vehicle application, verify the mounting and hydraulic connection details against the original part before installation. Nugeon 97-17626B is a practical choice when replacing a worn, sticking, or leaking caliper on the correct vehicle application.

• Replaces a leaking caliper housing or piston seal issue
• Addresses uneven braking caused by a sticking caliper piston
• Helps restore proper brake pedal response after hydraulic service
• Supports repair of corrosion-related caliper wear
• Provides a direct replacement path for brake caliper maintenance on select Honda Civic applications

Installation Notes and Tips

Confirm caliper orientation, inlet thread size, bleeder screw thread, and piston configuration before installation. Transfer or connect brake lines only after verifying the banjo bolt and copper washer requirements for the vehicle application. Bleed the brake system thoroughly after installation and inspect for leaks, pad clearance, and rotor contact.

Quality Assurance

This remanufactured caliper is built from cast iron with a rust-preventative finish and includes key service components such as dust boots and a bleeder screw. Nugeon 97-17626B is intended for brake repair work where a reman caliper is specified and the original fitment details match the vehicle application.