Nugeon 97-17704B Disc Brake Caliper - Rear Left

Rear Left Reman Brake Caliper for Jeep TJ and Wrangler

Nugeon 97-17704B is a remanufactured disc brake caliper for the rear left position on select 2003-2006 Jeep TJ and Jeep Wrangler models. It features a cast iron housing, a grey rust-preventative finish, and a 2-inch phenolic piston for dependable hydraulic braking performance.

This reman caliper w/ installation hardware product line focuses on service-ready brake hydraulics components for direct replacement applications. For Jeep TJ and Jeep Wrangler rear brake service, 97-17704B provides the core caliper assembly with the specified inlet and bleeder hardware details needed for the listed fitment.

Key Features

• Remanufactured disc brake caliper for rear left installation
• Fits 2003-2006 Jeep TJ, rear left
• Fits 2003-2006 Jeep Wrangler, rear left
• Cast iron caliper housing with rust-preventative finish
• Grey caliper color for a clean service replacement appearance
• Phenolic piston construction with 2-inch piston diameter
• Bleeder screw included
• Dust boots included
• Banjo bolt inlet fitting with 3/8-24 thread size
• Brake pad installation hardware, banjo bolt, and copper crush washers included where applicable

Detailed Description

Nugeon part number 97-17704B is a remanufactured rear left disc brake caliper built for select Jeep TJ and Jeep Wrangler applications from 2003 through 2006. The caliper uses a cast iron body with a rust-preventative finish and a phenolic piston to support consistent brake hydraulic operation in the rear braking system. The bleeder screw is included, and the inlet uses a banjo bolt connection with 3/8-24 thread sizing.

For buyers searching for a rear left brake caliper for 2003-2006 Jeep TJ or 2003-2006 Jeep Wrangler, 97-17704B matches the listed position and hardware configuration. This part number, 97-17704B, is a direct service replacement for the specified rear left brake caliper application.

What This Part Helps Address

• Brake fluid leakage at the rear caliper
• Uneven rear braking performance
• Sticking or seized caliper operation
• Corrosion on the caliper housing
• Bleeder screw service issues during brake maintenance

Installation Notes and Tips

Verify rear left position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, copper crush washers, and mounting surfaces during service. Bleed the brake system after installation to remove air from the hydraulic circuit. Confirm fitment against the vehicle’s brake configuration before ordering, especially on Jeep TJ and Jeep Wrangler rear brake repairs.

Quality Assurance

This remanufactured caliper is built with a cast iron housing, dust boots, and specified bleeder hardware for the listed application. Nugeon 97-17704B is intended to meet the fitment and component requirements shown for the rear left brake position on the supported Jeep TJ and Jeep Wrangler models.