Nugeon 97B00579A Disc Brake Caliper - Rear Left

Rear Left Brembo-Style Caliper for Nissan 350Z

Nugeon 97B00579A is a remanufactured rear left disc brake caliper for the 2003-2008 Nissan 350Z with Brembo design rear brake hardware. It features a black powder-coated aluminum housing, dual aluminum pistons, and a bleeder screw for serviceable brake system maintenance.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics built around OE-style fitment and service-ready components. For shoppers searching for a rear left brake caliper for Nissan 350Z Brembo design applications, this part number 97B00579A matches the listed configuration and finish.

• Fits 2003-2008 Nissan 350Z, rear left
• Remanufactured disc brake caliper with black powder coat finish
• Aluminum casting with aluminum pistons
• Dual-piston design with 40 mm piston diameter
• Bleeder screw included; dust boots included
• Inlet fitting uses M10-1.0 tube seat connection
• Housing cast numbers: 20.7313.05 / 20.7312.03

Detailed Product Overview

This rear left brake caliper is built for 2003-2008 Nissan 350Z models listed with a 2-piston Brembo design and black caliper finish. Nugeon 97B00579A uses an aluminum housing and aluminum pistons to match the specified brake architecture, while the powder-coated black finish supports a clean, OE-style appearance. The caliper includes a bleeder screw and dust boots, and the inlet port is threaded M10-1.0 with a tube seat fitting.

For buyers comparing Nissan 350Z rear brake caliper replacement options, 97B00579A provides a direct fitment-focused solution for the rear left position. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Addresses

• Leaking or sticking rear left caliper housing
• Uneven rear brake pad wear from piston or seal wear
• Corrosion or finish damage on the original caliper
• Bleeder screw service issues during brake bleeding
• Brake drag or reduced braking response at the rear left corner

Installation Notes and Tips

Verify the rear left position, Brembo-style 2-piston configuration, and M10-1.0 inlet thread before installation. Transfer or replace brake pads as needed, and follow proper brake bleeding procedures after installation. Confirm banjo bolt and copper crush washer requirements based on the vehicle’s brake hose setup, since package contents note these items where applicable.

Quality Assurance

This Nugeon remanufactured caliper is built as a service replacement for the listed Nissan 350Z application and is finished with a powder coat for added surface protection. Confirm housing cast numbers 20.7313.05 / 20.7312.03 and all brake connection details against the original unit before installation.