Nugeon 97P17812A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Ford Trucks

Nugeon TechShield 360 (tm) part 97P17812A is a remanufactured front right disc brake caliper for select Ford E-Series vans, Bronco, and F-Series trucks. It uses a cast iron body, a single phenolic piston, and a rust preventative grey finish for service-ready brake hydraulics replacement.

The TechShield 360 (tm) line focuses on brake caliper protection and dependable fitment for older Ford applications. This caliper includes a bleeder screw, dust boots, and brake pad installation hardware with banjo bolt and copper crush washers where applicable, making it a practical replacement for front right brake service on Ford E-100 Econoline, Ford E-150 Econoline, Ford Bronco, Ford F-100, Ford F-150, and Ford F-250 models.

Key Features

• Remanufactured disc brake caliper from Nugeon
• TechShield 360 (tm) product line for added corrosion resistance
• Front right position
• Cast iron caliper body with rust preventative finish
• Single 3 in. (73 mm) phenolic piston
• Bleeder screw included
• Dust boots included
• Banjo bolt inlet fitting with 3/8-24 inlet thread
• Brake pad installation hardware included where applicable
• Grey caliper color

Vehicle Fitment

• Fits 1973-1983 Ford E-100 Econoline, front right.
• Fits 1975-1983 Ford E-100 Econoline Club Wagon, front right.
• Fits 1975-1983 Ford E-150 Econoline, front right.
• Fits 1975-1983 Ford E-150 Econoline Club Wagon, front right.
• Fits 1976-1979 Ford Bronco, front right.
• Fits 1973-1979 Ford F-100, front right.
• Fits 1975-1979 Ford F-150, front right.
• Fits 1973-1979 Ford F-250, front right, 1-piston caliper.

What This Caliper Helps Address

• Leaking or sticking front right brake caliper
• Uneven braking caused by worn piston or seals
• Corrosion on the original caliper body
• Soft or inconsistent brake pedal response from caliper wear
• Brake drag or reduced pad release at the wheel

Installation Notes

Verify the banjo bolt inlet connection, 3/8-24 thread size, and front right application before installation. Transfer or replace brake pads as needed, and inspect hoses, rotors, and mounting surfaces during service. Bleeder screw and dust boots are included; caliper and pad hardware is included where applicable, while pads, bracket, and bracket bolts are not included.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured calipers are built for brake hydraulic replacement on the listed Ford applications. Part number 97P17812A is specified for the fitments shown above and is intended for direct front right service on those vehicles.