Nugeon 97P17829A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Ford Trucks

This Nugeon TechShield 360 disc brake caliper is a remanufactured front right replacement for select Ford F-250, F-350, and Econoline applications. Part number 97P17829A is built for direct-fit brake hydraulic service on the listed vehicles, with OE-style mounting and hydraulic connections.

Key Features

• Remanufactured disc brake caliper for front right placement
• Cast iron housing with rust preventative grey finish
• Phenolic piston design with 2 pistons and 55 mm outside diameter
• Bleeder screw included; bleeder screw thread size 3/8-24
• Banjo bolt inlet fitting with 3/8-24 inlet thread size
• Dust boots included for added protection at the piston area
• Brake pad installation hardware included where applicable
• Compatible with housing cast numbers 573 and 471

Product Details

Nugeon TechShield 360 is a brake hydraulics product line focused on remanufactured calipers with OE-style fit and service-ready hardware details. This front right disc brake caliper, part number 97P17829A, uses a cast iron body, phenolic pistons, and a rust preventative finish to support dependable brake system restoration on the specified Ford truck and van applications. It is a direct replacement for 1986-1994 Ford F-250 and F-350 front right brake service, as well as 1986-1991 Ford E-250 Econoline, E-250 Econoline Club Wagon, E-350 Econoline, and E-350 Econoline Club Wagon front right applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Leaking or sticking front right brake caliper
• Uneven braking caused by worn hydraulic components
• Corrosion on the caliper body or piston area
• Brake drag from damaged piston seals or dust boots
• Service issues tied to worn bleeder or inlet connections

Installation Notes and Tips

Verify the vehicle’s front right position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect brake hoses, copper crush washers, and adjacent hydraulic components for wear or contamination. Bleed the brake system thoroughly after installation to remove air from the hydraulic circuit.

Quality Assurance

Built as a remanufactured brake caliper under Nugeon’s TechShield 360 line, this unit is prepared for brake hydraulic replacement on the listed Ford applications. Confirm cast numbers 573 or 471 and match the vehicle fitment details for proper application.