Nugeon 97P17829B Disc Brake Caliper - Front Left

Front Left Disc Brake Caliper for Ford Trucks

This Nugeon TechShield 360 disc brake caliper is a remanufactured front left replacement for select Ford heavy-duty trucks and vans. It is built for 1986-1994 Ford F-250 and F-350 models, plus 1986-1991 Ford E-250 and E-350 Econoline applications.

Part number 97P17829B is finished in grey with a rust preventative coating and uses a cast iron housing with phenolic pistons for service-focused brake hydraulics repair.

Key Features

• Remanufactured disc brake caliper for the front left position
• Fits 1986-1994 Ford F-250 and Ford F-350, front left
• Fits 1986-1991 Ford E-250 Econoline, front left
• Fits 1986-1991 Ford E-250 Econoline Club Wagon, front left
• Fits 1986-1991 Ford E-350 Econoline, front left
• Fits 1986-1991 Ford E-350 Econoline Club Wagon, front left
• Grey caliper with rust preventative finish
• Cast iron housing with 2 phenolic pistons
• Bleeder screw included
• Dust boots included
• Banjo bolt inlet fitting with 3/8-24 inlet thread
• Package contents include brake pad installation hardware with banjo bolt and copper crush washers where applicable

Product Details

Nugeon TechShield 360 is a brake hydraulics product line focused on replacement calipers prepared for direct service on covered Ford applications. This 97P17829B caliper uses a 2-inch (55 mm) piston design, a 3/8-24 bleeder screw thread, and a 3/8-24 inlet port thread with banjo bolt connection. The housing cast numbers 573 and 471 identify the caliper casting used for these applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Leaking brake fluid at the caliper body or bleeder area
• Uneven braking caused by a sticking front left caliper
• Corrosion on the caliper housing or piston area
• Brake drag from worn internal hydraulic components
• Restoration of front brake performance on older Ford F-250, F-350, and Econoline models

Installation Notes

Verify the front left position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, since pads are not included. Inspect the brake hose, copper crush washers, and mounting surfaces during service, and bleed the hydraulic system after installation to remove air from the line.

Quality Assurance

This Nugeon remanufactured caliper is built for brake service on the listed Ford applications and includes a rust preventative finish, dust boots, and a bleeder screw for installation support.