Nugeon 97S02751B Disc Brake Caliper - Front Right

Remanufactured Front Right Brake Caliper

Nugeon 97S02751B is a remanufactured disc brake caliper for the front right position on select Mercedes-Benz ML models. It is built with an aluminum housing, silver powder coat finish, and the brake hardware needed for pad installation where applicable.

This Nugeon reman caliper is a direct service replacement for 2000-2001 Mercedes-Benz ML430 front right, 2000-2001 Mercedes-Benz ML55 AMG front right, and 2002 Mercedes-Benz ML500 front right and ML55 AMG front right applications within the listed chassis limits.

Key Features

• Remanufactured disc brake caliper for front right brake service
• Silver powder-coated aluminum housing
• Bleeder screw included
• Dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Four-piston design with 40 mm and 44 mm piston diameters
• Brake pad installation hardware included where applicable
• Housing cast numbers: 20.7233.03 / 20.7046.04

Product Details

The Nugeon Reman Caliper w/ Installation Hardware line focuses on service-ready brake hydraulics components that restore hydraulic function and caliper operation without changing the original brake layout. Part number 97S02751B uses an aluminum casting, powder-coated silver finish, and integrated dust boots for a clean, OE-style replacement on the specified Mercedes-Benz ML430, ML55 AMG, and ML500 front right positions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Sticking or seized front right caliper movement
• Uneven brake pad wear on the front axle
• Brake fluid leakage at the caliper body or bleeder area
• Reduced braking response from a worn hydraulic caliper
• Corrosion or finish damage on the original caliper housing

Installation Notes

Verify chassis number and front right fitment before ordering. This caliper uses a banjo bolt inlet connection and M10-1.0 inlet thread size, so confirm the brake hose and fitting style match the vehicle. Bleeder screw hardware is included; pads, bracket, and caliper slides are not included.

For best results, inspect brake hoses, copper crush washers, and pad condition during installation, then bleed the brake system thoroughly after replacement. Confirm rotor condition and pad fitment before returning the vehicle to service.

Quality Assurance

This remanufactured Nugeon brake caliper is built for service replacement use on the listed Mercedes-Benz applications and is finished to support corrosion resistance in normal brake service conditions. Part number 97S02751B is specified for the front right position on the confirmed ML430, ML55 AMG, and ML500 fitments.