Nugeon 99-00529B Disc Brake Caliper - Front Right

Remanufactured Front Right Caliper

Nugeon 99-00529B is a remanufactured disc brake caliper for the front right position, built for Nissan Pulsar NX and Nissan Sentra applications that use casting number 1708. This reman caliper with installation hardware is supplied with the bracket, slides, dust boots, bleeder screw, and brake pad installation hardware where applicable.

Key Features

• Remanufactured disc brake caliper with rust preventative finish
• Front right fitment for 1987-1989 Nissan Pulsar NX and 1987-1988 Nissan Sentra
• Cast iron housing with a steel piston and 2-inch (48 mm) piston diameter
• Bracket included for applications calling for casting number 1708
• Bleeder screw included with M10-1.0 thread and banjo bolt inlet fitting
• Caliper slides and dust boots included
• Grey caliper finish for a clean replacement appearance

Product Details

The Nugeon 99-00529B reman caliper is built for brake hydraulic service on front right Nissan applications that match the listed casting and mounting configuration. It uses a single steel piston in a cast iron body, with a banjo bolt inlet and M10-1.0 inlet thread size. The included bracket and slides support proper caliper mounting on the specified vehicles, while the rust preventative finish helps protect the housing during service.

This part cross-references no listed alternate part numbers in the provided data. For fitment-focused searches, this is a remanufactured front right brake caliper for 1987-1989 Nissan Pulsar NX and 1987-1988 Nissan Sentra, part number 99-00529B.

Common Brake Issues It Can Address

• Leaking or seized front right caliper
• Uneven braking caused by worn piston or slide components
• Brake drag from damaged dust boots or sticking hardware
• Corrosion on the caliper body or mounting bracket
• Loss of braking performance from a failing hydraulic caliper assembly

Installation Notes

Verify casting number 1708, front right position, and inlet thread size before installation. Use the correct banjo bolt and copper crush washers where applicable, and bleed the brake system after installation to remove air from the hydraulic circuit. Inspect pads, hoses, and rotor condition during service to confirm the repair addresses the full brake system.

Quality Assurance

Nugeon remanufactures brake calipers to restore serviceable hydraulic function for direct replacement applications. Part number 99-00529B is built as a remanufactured caliper assembly for Nissan Pulsar NX and Nissan Sentra front right brake service, with the listed mounting and hydraulic features matched to the application data.