Nugeon 99-00876A Disc Brake Caliper - Front Right

Front Right Reman Brake Caliper

Nugeon 99-00876A is a remanufactured disc brake caliper for the front right position on select Hyundai Azera models. It is built with a cast iron housing, a steel piston, and a rust preventative finish for service-ready brake hydraulics replacement.

This reman caliper w/ installation hardware line focuses on restoring proper hydraulic braking performance with the correct bracket, bleeder screw, dust boots, and caliper slides included. For 2012-2017 Hyundai Azera front right brake service, 99-00876A provides the key components needed for a direct-fit caliper replacement.

Key Features

• Fits 2012-2017 Hyundai Azera, front right
• Remanufactured disc brake caliper from Nugeon
• Cast iron housing with grey rust preventative finish
• Single 60 mm steel piston
• Bracket included for the front right application
• Bleeder screw included with M10-1.0 thread
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Package contents include brake pad installation hardware with banjo bolt and copper crush washers where applicable
• Part number: 99-00876A

Product Details

Nugeon 99-00876A is engineered for the front right brake position on the 2012-2017 Hyundai Azera. The remanufactured design uses a cast iron body and steel piston to match the demands of disc brake hydraulic operation, while the rust preventative coating helps protect the caliper housing during service. The included bracket, slides, dust boots, and bleeder screw support a complete caliper replacement on the specified Hyundai Azera application. If you are sourcing a front right Hyundai Azera brake caliper, 99-00876A is the correct part number to verify against your vehicle and brake setup.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Sticking or seized front right caliper movement
• Uneven brake pad wear on the front axle
• Brake fluid leakage at the caliper body or bleeder area
• Reduced braking response from a worn hydraulic caliper
• Corrosion-related caliper performance problems

Installation Notes

Verify the front right position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, rotor, and mounting points for wear or damage during service. Bleed the brake system after installation to remove air from the hydraulic circuit and confirm proper pedal feel.

Quality Assurance

This Nugeon reman caliper is built as a remanufactured brake hydraulics component for the specified Hyundai Azera fitment. The caliper is supplied with the listed hardware and protective components shown in the product data for accurate service replacement.