Nugeon 99-00877B Disc Brake Caliper - Front Right

Front Right Reman Caliper for Kia and Hyundai

Nugeon 99-00877B is a remanufactured disc brake caliper with installation hardware for the front right position. It is built for select Kia Forte5, Kia Forte Koup, and Hyundai Veloster applications, with a supplied mounting bracket for direct brake service on the listed vehicles.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on replacement brake hydraulics with application-specific fitment and included service hardware where applicable. This caliper uses a cast iron housing, steel piston, grey rust-preventative finish, and integrated dust boots to support dependable brake operation on the front right corner.

• Remanufactured disc brake caliper for front right brake service
• Supplied with mounting bracket for the listed applications
• Cast iron housing with steel piston and rust-preventative finish
• Bleeder screw included with M10-1.0 thread
• Banjo inlet fitting with copper crush washers where applicable
• Caliper slides, dust boots, and caliper/pad hardware included
• Brake pad installation hardware included where applicable

This Nugeon 99-00877B caliper is a direct replacement for front right brake service on select 2013-2018 Hyundai Veloster, 2014-2018 Kia Forte5, and 2014-2017 Kia Forte Koup models. It is built around a 57 mm piston and bracketed design to match the listed brake configuration, making it a practical choice when replacing a worn, sticking, or leaking caliper on these Kia and Hyundai platforms.

Common Brake Problems This Caliper Addresses

• Brake fluid leakage at the caliper body or bleeder area
• Uneven front brake pad wear on the right side
• Dragging or seized caliper movement
• Reduced braking response from a worn piston or seal assembly
• Corrosion-related caliper performance issues

Installation Notes

Verify front right fitment before installation and confirm the banjo inlet, M10-1.0 thread size, and bracketed caliper layout match the original part. Transfer or replace brake fluid as needed during service, and inspect pads, rotors, and brake hoses for wear before returning the vehicle to service. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Quality Assurance

Each Nugeon remanufactured caliper is processed as a brake hydraulic replacement component with application-specific hardware and corrosion-resistant finishing for the listed vehicles. Part number 99-00877B is intended for direct replacement use on the confirmed fitments shown above.