Nugeon 99-00916A Disc Brake Caliper - Front Left

Remanufactured Front Left Caliper

The Nugeon 99-00916A is a remanufactured disc brake caliper with installation hardware for select 1988-1989 Honda Civic and 1988-1989 Honda CRX front left applications. Built with a cast iron housing, steel piston, and rust preventative finish, it is configured for direct brake hydraulic replacement where the original caliper uses a banjo bolt inlet.

Nugeon’s Reman Caliper w/ Installation Hardware line focuses on restoring brake function with application-specific components and remanufactured housings. For buyers searching for a front left brake caliper for Honda Civic or Honda CRX, this part number 99-00916A matches the listed OE-style fitment and hardware configuration.

• Fits 1988-1989 Honda Civic, front left
• Fits 1988-1989 Honda CRX, front left
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust preventative finish
• Steel piston with dust boots and bleeder screw included
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Brake pad installation hardware included where applicable
• Grey caliper finish for a service-ready appearance

Detailed Product Overview

This Nugeon brake caliper is built for the front left position on 1988-1989 Honda Civic and Honda CRX models. It uses a single 51 mm steel piston and includes caliper slides, a bleeder screw, dust boots, and a mounting bracket to match the listed brake hydraulic setup. The housing cast numbers 2042 and 2049 are noted for identification during service and comparison.

Part number 99-00916A is a practical replacement when the original caliper shows wear, corrosion, sticking piston movement, or hydraulic leakage. The remanufactured design and rust preventative coating support a clean installation on the front brake system while maintaining the correct inlet and bleeder thread specifications.

Common Brake Issues This Part Addresses

• Brake fluid leakage at the caliper body or bleeder area
• Uneven braking caused by a sticking or seized piston
• Corrosion on the caliper housing or slide components
• Poor brake pedal response from a worn hydraulic caliper
• Front left brake drag on Honda Civic or Honda CRX applications

Installation Notes

Verify front left fitment before installation on 1988-1989 Honda Civic and 1988-1989 Honda CRX models. Confirm the banjo bolt inlet, M10-1.0 thread sizing, and bracket configuration match the vehicle’s original brake setup. Inspect brake hoses, pads, and mounting surfaces during service, and bleed the hydraulic system after installation to remove air from the circuit.

Use the included brake pad installation hardware where applicable, and compare the existing caliper casting numbers and port style before final assembly. Part number 99-00916A is intended for direct replacement in the listed applications only.

Quality Assurance

This remanufactured Nugeon caliper is built from cast iron and finished with a rust preventative coating for service use. The product includes the listed hydraulic and mounting components shown in the specifications, supporting a consistent replacement for the specified Honda front brake applications.