Nugeon 99-01181A Disc Brake Caliper - Rear Right

Rear Right Reman Brake Caliper for Mazda CX-9

Nugeon 99-01181A is a remanufactured disc brake caliper for the rear right position on select Mazda CX-9 models. It is built with a cast iron housing, grey rust-preventative finish, and a 43 mm steel piston for service on the rear brake hydraulic system.

This Nugeon Reman Caliper w/ Installation Hardware line focuses on replacement calipers restored for direct-fit brake service. For this application, the caliper includes a mounting bracket, bleeder screw, dust boots, and caliper slides, along with brake pad installation hardware and banjo bolt/copper crush washers where applicable.

Key Features

• Fits 2007-2015 Mazda CX-9, rear right
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust-preventative grey finish
• 43 mm steel piston for rear brake operation
• Bleeder screw included with M10-1.0 thread
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet port thread
• Brake pad installation hardware included where applicable

Detailed Description

The Nugeon 99-01181A rear right brake caliper is a remanufactured replacement for 2007-2015 Mazda CX-9 models. It is configured with a single 43 mm steel piston, cast iron construction, and a rust-preventative finish to support dependable brake service in the rear hydraulic circuit. The included bracket, slides, dust boots, and bleeder screw help match the original caliper layout for this application.

Use this part when servicing a worn, sticking, leaking, or seized rear right caliper on a Mazda CX-9. The part number 99-01181A is the correct reference for this rear right reman caliper application, and 99-01181A may also be used when searching for a direct replacement for the same vehicle fitment.

What This Caliper Helps Address

• Brake fluid leakage at the rear right caliper
• Uneven rear brake pad wear
• Dragging or sticking caliper movement
• Reduced braking response from a worn piston or seal assembly
• Corrosion-related caliper service issues on the Mazda CX-9

Installation Notes and Tips

Confirm rear right placement before installation. Verify the banjo bolt inlet connection, M10-1.0 thread sizing, and bleeder screw orientation against the original part. Transfer or replace brake pads as needed, and inspect brake hoses, mounting points, and rotor condition during service. Bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

Nugeon remanufactured brake calipers are rebuilt for brake service applications using a remanufacturing process that restores the caliper housing and operating components for replacement use. Part number 99-01181A is specified for 2007-2015 Mazda CX-9 rear right fitment.