Nugeon 99-01181B Disc Brake Caliper - Rear Left

Rear Left Reman Brake Caliper for Mazda CX-9

Nugeon 99-01181B is a remanufactured disc brake caliper for the rear left position on select Mazda CX-9 models. It includes a mounting bracket and installation hardware details specified for the application, along with a rust preventative finish and grey cast iron housing for service replacement use.

Key Features

• Fits 2007-2015 Mazda CX-9, rear left
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust preventative finish
• Single-piston design with 43 mm piston diameter
• Bleeder screw included with M10-1.0 thread
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with copper crush washers where applicable
• Part number 99-01181B for application matching

Product Details

This Nugeon reman caliper is built for rear left brake service on the Mazda CX-9 from 2007 through 2015. The unit uses a cast iron body, steel piston, and rust preventative finish to support dependable hydraulic braking performance in a direct replacement format. Nugeon 99-01181B is supplied with the bracket, bleeder screw, caliper slides, and dust boots, making it a practical choice when replacing a worn or sticking rear brake caliper on the CX-9.

The Nugeon reman caliper w/ installation hardware product line focuses on service-ready brake hydraulics components for straightforward replacement work. For this application, the caliper is configured with a banjo bolt inlet, M10-1.0 inlet thread, and M10-1.0 bleeder thread to match the listed vehicle fitment. Part number 99-01181B is the reference to use when ordering for the rear left position on the Mazda CX-9.

Common Repair Reasons

• Rear brake drag or a caliper that does not release properly
• Brake fluid seepage at the caliper body or bleeder area
• Uneven rear brake pad wear on the Mazda CX-9
• Corrosion on the caliper housing or slide components
• Reduced braking response from a worn hydraulic caliper assembly

Installation Notes

Verify rear left fitment before installation on 2007-2015 Mazda CX-9 models. Confirm the banjo bolt connection, M10-1.0 thread sizes, and bracket configuration against the original part before assembly. Inspect brake hoses, pads, and rotor condition during service, and bleed the hydraulic system after installation to remove air from the circuit.

Quality Assurance

This remanufactured caliper is built with a rust preventative finish, dust boots, caliper slides, and a bleeder screw for service replacement use. The cast iron housing and steel piston support consistent brake system operation when installed on the listed Mazda CX-9 rear left application.