Nugeon 99-01407A Disc Brake Caliper - Front Left

Remanufactured Brake Caliper for Disc Brake Service

Nugeon 99-01407A is a remanufactured disc brake caliper with installation hardware for brake hydraulic service. It features a cast iron housing, grey rust-preventative finish, a steel piston, and included slides, dust boots, bracket, and bleeder screw for a direct replacement-style repair.

Compatible with brake service applications that require a 54 mm single-piston caliper, this Nugeon reman caliper is built for drivers searching for a reman caliper with installation hardware, banjo bolt inlet, and M10-1.0 thread specifications. The 99-01407A part number is a useful reference when matching a replacement caliper for the correct brake setup.

Key Features

• Remanufactured disc brake caliper for brake hydraulic replacement
• Cast iron housing with grey rust-preventative finish
• Single 54 mm steel piston
• Bleeder screw included with M10-1.0 thread
• Bracket included for the specified brake assembly
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Part number 99-01407A for catalog matching

Product Details

Nugeon’s Reman Caliper w/ Installation Hardware line focuses on replacement brake calipers that restore hydraulic function while matching the original brake architecture. This unit is finished in grey with rust prevention treatment and uses a cast iron body for the caliper housing. The design includes a single steel piston, integrated bleeder screw, bracket, slides, and dust boots. The package contents also note brake pad installation hardware with banjo bolt and copper crush washers where applicable.

For shoppers comparing brake caliper replacement parts for a Honda Civic, Toyota Corolla, or similar disc brake applications, 99-01407A is a catalog-ready reference that helps narrow the correct hydraulic caliper configuration by inlet style, thread size, piston diameter, and bracketed design.

Common Brake Issues This Part Addresses

• Leaking caliper seals or damaged dust boots
• Uneven braking caused by sticking caliper slides
• Corrosion on the caliper body or piston area
• Soft or inconsistent brake pedal response from caliper wear
• Brake drag related to a seized piston or bleeder issue

Installation Notes

Verify inlet fitting type, inlet port thread size, bleeder thread size, piston diameter, and bracket configuration before installation. This caliper uses a banjo bolt inlet and M10-1.0 thread specifications, so the brake hose and hardware must match the vehicle’s original setup. Bleeding the brake system after installation is required to remove air from the hydraulic circuit.

Confirm left/right orientation by housing cast numbers and compare the removed caliper to the replacement before bolting it in place. If the vehicle uses copper crush washers with the banjo connection, replace them during service where applicable.

Quality Assurance

This Nugeon remanufactured brake caliper is built as a replacement hydraulic component for disc brake service and is supplied with the listed core hardware and sealing components. Part number 99-01407A should be matched against the original caliper specifications and vehicle brake system requirements before installation.