Nugeon 99-01421A Disc Brake Caliper - Front Left

Remanufactured Disc Brake Caliper

Nugeon 99-01421A is a remanufactured disc brake caliper with installation hardware for brake hydraulic service. This reman caliper w/ installation hardware features a grey rust-preventative finish, a cast iron housing, and a single 54 mm steel piston for consistent braking performance. It is built for applications that use a banjo bolt inlet and M10-1.0 inlet thread size.

The Nugeon reman caliper line focuses on service-ready brake hydraulics with key wear components addressed during remanufacturing. Part number 99-01421A includes a bleeder screw, caliper slides, dust boots, and bracket assembly details that match the original brake setup where applicable.

Key Features

• Remanufactured disc brake caliper, part number 99-01421A
• Grey caliper finish with rust preventative coating
• Cast iron housing with one 54 mm steel piston
• Bleeder screw included; M10-1.25 x 25 bleeder thread
• Bracket included with caliper slides and dust boots
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Brake pad installation hardware included where applicable

Detailed Description

This Nugeon brake caliper is a direct-fit style replacement for disc brake hydraulic service on select vehicles that use the listed mounting and port specifications. It is a practical choice when replacing a sticking, leaking, or unevenly operating caliper on a Honda Civic or similar application that matches the OE brake layout. The 99-01421A caliper is supplied as a remanufactured unit with the bracket, slides, dust boots, and bleeder screw already accounted for in the assembly.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Fix

• Brake drag caused by a seized piston or slide hardware
• Brake fluid leakage at the caliper body or bleeder area
• Uneven braking from a worn or corroded caliper assembly
• Poor pedal response related to hydraulic caliper wear
• Brake noise or pull caused by caliper movement issues

Installation Notes and Tips

Verify caliper mounting style, inlet thread size, bleeder thread size, and bracket configuration before installation. This unit uses a banjo bolt inlet and M10-1.0 inlet thread size, with an M10-1.25 bleeder screw thread. Brake pad installation hardware is included where applicable, but pads are not included. Always bleed the brake system after installation and inspect hoses, washers, and mating surfaces for wear or damage.

Quality Assurance

Each Nugeon reman caliper is rebuilt for brake service with attention to core housing condition, piston operation, and sealing components. The remanufactured design supports a cost-effective replacement path for brake hydraulic repair while maintaining the required fitment and hardware specifications for the application.