Nugeon 99-01426A Disc Brake Caliper - Rear Left

Rear Left Reman Brake Caliper for Grand Vitara

Nugeon 99-01426A is a remanufactured disc brake caliper for the rear left position on select Suzuki Grand Vitara models. It is built with a cast iron housing, grey rust-preventative finish, and a 43 mm steel piston for direct brake hydraulic service.

This Nugeon reman caliper w/ installation hardware line focuses on service-ready brake hydraulics for applications that need a replacement caliper with the correct bracket, bleeder screw, slides, dust boots, and banjo-bolt inlet configuration.

Key Features

• Remanufactured disc brake caliper for rear left installation
• Fits 2006-2013 Suzuki Grand Vitara, rear left
• Cast iron housing with rust-preventative grey finish
• 43 mm steel piston with single-piston design
• Bracket included for the specified application
• Bleeder screw included; banjo bolt inlet fitting
• Caliper slides and dust boots included
• Brake pad installation hardware included where applicable

Detailed Description

Nugeon 99-01426A is a remanufactured rear left disc brake caliper engineered for 2006-2013 Suzuki Grand Vitara models. It uses a cast iron body, a single 43 mm steel piston, and a banjo-bolt inlet with M10-1.0 thread size. The caliper also includes the mounting bracket, slides, dust boots, and bleeder screw for the listed application. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

For buyers searching for a rear left brake caliper for Suzuki Grand Vitara 2006-2013, Nugeon 99-01426A provides the key hydraulic and mounting details needed for a direct replacement selection. The housing cast numbers 4320 and 4319 are listed for identification during comparison.

Common Brake Issues This Part Can Address

• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear braking caused by a sticking piston
• Corrosion on the caliper housing or slides
• Reduced brake response from a worn hydraulic caliper assembly
• Brake drag related to damaged dust boots or seized hardware

Installation Notes and Tips

Confirm rear left fitment on the vehicle before installation. Verify the banjo-bolt inlet, M10-1.0 inlet thread size, and M7-1.0 bleeder screw thread size against the removed part. Inspect brake hoses, pads, and rotor condition during service, and bleed the brake system after installation to remove air from the hydraulic circuit.

Because this caliper is supplied with a bracket and installation hardware for the listed application, compare the existing mounting points and cast numbers before assembly on your Suzuki Grand Vitara.

Quality Assurance

Nugeon remanufactured brake components are processed for brake hydraulic service and finished with rust-preventative coating to support corrosion resistance in everyday use. Part number 99-01426A is identified for the specified rear left Grand Vitara application.