Nugeon 99-01561A Disc Brake Caliper - Front Left

Front Left Brake Caliper for Toyota Paseo

Nugeon 99-01561A is a remanufactured disc brake caliper for the front left position on 1992-1995 Toyota Paseo models. It is supplied with a mounting bracket and installation hardware details specified for the application, making it a direct-fit brake hydraulics replacement for this vehicle range.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake calipers built for application-specific fitment. For Toyota Paseo front brake service, this product combines a cast iron housing, steel piston, and rust-preventative finish to support dependable braking performance in a replacement caliper assembly.

• Remanufactured disc brake caliper for the front left side
• Fits 1992-1995 Toyota Paseo, front left
• Cast iron caliper housing with grey rust-preventative finish
• Single steel piston with 51 mm outside diameter
• Includes bleeder screw, dust boots, caliper slides, and bracket
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw thread: M7-1.0 x 32

This Nugeon 99-01561A caliper is built for Toyota Paseo front brake repair where the original caliper has seized, leaked, or worn unevenly. It is a remanufactured replacement for the 1992-1995 Toyota Paseo, front left, and uses the specified bracketed design and hydraulic connections for the listed application. The part number 99-01561A is useful when matching the correct front left caliper configuration for this vehicle.

Common Brake Issues It Can Address

• Brake fluid leakage from a worn caliper body or piston seal
• Uneven pad wear caused by sticking caliper slides or piston movement
• Reduced braking response from a seized front left caliper
• Brake drag or pulling during stops on the Toyota Paseo
• Corrosion-related caliper replacement on older brake systems

Installation Notes

Verify the front left position, bracket style, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, rotor, and mounting points for wear or damage during service. Bleed the brake system after installation to remove air and restore proper hydraulic operation. Confirm all fasteners and copper crush washers are seated correctly where applicable.

Quality Assurance

This remanufactured caliper is built from cast iron with a rust-preventative finish and includes the specified hydraulic and mounting components for the listed application. Part number 99-01561A is cataloged for 1992-1995 Toyota Paseo front left brake service.