Nugeon 99-01582A Disc Brake Caliper - Front Right

Nugeon Reman Caliper for Toyota T100

The Nugeon 99-01582A is a remanufactured disc brake caliper for the front right position on select 1993-1998 Toyota T100 1/2 Ton models. It is built with a cast iron housing, grey rust-preventative finish, and installation hardware details that support a direct brake service replacement.

Key Features

• Remanufactured disc brake caliper for front right Toyota T100 applications
• Cast iron housing with grey rust-preventative finish
• Single 60 mm steel piston
• Bracket included for the listed application
• Bleeder screw included with M7-1.0 thread
• Caliper slides and dust boots included
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Brake pad installation hardware included where applicable

Product Details

Built for the 1993-1998 Toyota T100 front right brake position, part number 99-01582A is a reman caliper assembled for hydraulic brake service on the front axle. The unit uses a 2-inch steel piston, cast iron construction, and a rust-preventative coating to support dependable operation in a demanding brake environment. The included bracket, slides, dust boots, and bleeder screw help simplify replacement on the specified Toyota T100 application.

Nugeon’s Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics for direct-fit service work. For buyers searching for a Toyota T100 front right brake caliper, Toyota T100 reman caliper, or Nugeon 99-01582A, this part matches the listed vehicle and position details without requiring guesswork.

What It Helps Address

• Brake fluid leakage from a worn caliper housing or piston seal area
• Uneven braking caused by a sticking or seized caliper piston
• Poor pad movement from worn slides or damaged dust boots
• Brake pull or inconsistent front brake response on the Toyota T100
• Corrosion-related caliper wear on older front brake assemblies

Installation Notes and Tips

Verify the front right position, banjo bolt inlet style, and M10-1.0 inlet thread before installation. Inspect brake hoses, pads, and rotor condition during service, and bleed the hydraulic system thoroughly after replacement. Confirm the bracket and hardware configuration against the vehicle before assembly, especially on 1993-1998 Toyota T100 1/2 Ton models.

Quality Assurance

This remanufactured caliper is built with a cast iron body, steel piston, bleeder screw, slides, and dust boots for the listed application. Part number 99-01582A is intended for direct brake service on compatible Toyota T100 front right fitments and is supplied as a remanufactured brake hydraulic component.