Nugeon 99-01848B Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Kia Rondo

This Nugeon remanufactured disc brake caliper is built for the rear left position on 2009-2012 Kia Rondo models. Part number 99-01848B is a direct-fit brake hydraulics replacement with a grey rust-preventative finish and the mounting bracket supplied for the listed application.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake calipers with application-specific hardware details. For Kia Rondo rear brake service, 99-01848B provides the caliper body, bracket, slides, dust boots, and bleeder screw needed for a proper hydraulic brake repair.

Key Features

• Fits 2009-2012 Kia Rondo, rear left
• Remanufactured disc brake caliper with cast iron housing
• Grey finish with rust preventative coating
• Includes bracket, caliper slides, dust boots, and bleeder screw
• Single-piston design with 38 mm steel piston
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Bleeder screw thread: M10-1.0 x 28
• Part number 99-01848B

Detailed Description

Nugeon 99-01848B is a remanufactured rear left disc brake caliper for the 2009, 2010, 2011, and 2012 Kia Rondo. It is built with a cast iron housing, steel piston, and rust preventative finish to match the demands of brake hydraulic service. The supplied bracket and slides support a direct replacement for the listed rear left position, while the bleeder screw and dust boots address key service points during caliper replacement. Part number 99-01848B is the correct reference when searching for a rear left Kia Rondo brake caliper replacement.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Rear brake drag caused by a sticking caliper piston
• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear brake wear on a Kia Rondo
• Corrosion-related caliper seizure on the rear left side
• Restoring hydraulic brake pressure at the rear wheel

Installation Notes and Tips

Verify rear left fitment before installation on 2009-2012 Kia Rondo models. Confirm the banjo bolt inlet connection, M10-1.0 thread size, and bleeder screw thread before assembly. Transfer or replace brake pads and related wear items as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Part number 99-01848B should be matched to the vehicle position and brake line connection before final torque procedures.

Quality Assurance

This Nugeon remanufactured caliper is built as a service replacement for the listed Kia Rondo rear left application and is finished with rust preventative coating for added corrosion resistance in brake service environments.