Nugeon 99-01864A Disc Brake Caliper - Front Left

Front Left Reman Caliper for Elantra

Nugeon 99-01864A is a remanufactured disc brake caliper for the front left position on select 2017-2020 Hyundai Elantra models. It is supplied with a mounting bracket and installation hardware details are listed in the product contents for the applicable application.

This reman caliper uses a cast iron body with a grey rust-preventative finish, a steel piston, and a single 57 mm piston for consistent hydraulic actuation. The assembly includes a bleeder screw, dust boots, caliper slides, and brake pad installation hardware, and it is built around a Mando caliper design with a banjo inlet fitting.

• Fits 2017-2020 Hyundai Elantra, front left
• Remanufactured disc brake caliper with bracket included
• Grey rust-preventative finish on cast iron construction
• Single 57 mm steel piston
• Bleeder screw, dust boots, caliper slides, and hardware included
• Banjo inlet fitting with M10-1.0 thread size
• Brake pad FMSI number D1912 application

Product Details

Nugeon 99-01864A is built for drivers servicing the front brake hydraulic system on a Hyundai Elantra. The caliper is remanufactured to restore clamping force at the wheel end, and the included bracket supports the specified front left installation. The design uses a M10-1.0 inlet thread, M10-1.0 bleeder thread, and a banjo-style inlet connection for the listed application. If you are searching for a front left brake caliper for 2017, 2018, 2019, or 2020 Hyundai Elantra models, part number 99-01864A matches the confirmed fitment shown here.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues It May Address

• Uneven front brake pad wear on the left side
• Brake drag caused by a sticking caliper piston or slide
• Reduced braking response from a worn hydraulic caliper assembly
• Brake fluid seepage at the bleeder or inlet connection
• Noisy or inconsistent front brake operation after caliper wear

Installation Notes

Verify front left fitment before installation on 2017-2020 Hyundai Elantra models. Transfer only the components required by the application and confirm the banjo bolt and copper crush washer setup where applicable. Inspect brake hoses, pads, and rotor condition during service, and bleed the brake system after installation to remove air from the hydraulic circuit. Part number 99-01864A should be matched to the vehicle position and brake hardware specified for the repair.

Quality Assurance

This Nugeon reman caliper is remanufactured from a cast iron core and finished with a rust-preventative coating for brake service use. The assembly is configured to the listed OE-style application details for the Hyundai Elantra front left position.