Nugeon 99-01864B Disc Brake Caliper - Front Right

Nugeon Front Right Brake Caliper for Elantra

The Nugeon 99-01864B is a remanufactured disc brake caliper for the front right position on select 2017-2020 Hyundai Elantra models. It is supplied with a mounting bracket and installation hardware details are included in the package contents where applicable, making it a direct-fit brake hydraulics replacement for this application.

Key Features

• Remanufactured front right disc brake caliper
• Fits 2017-2020 Hyundai Elantra, front right
• Brand line: Reman Caliper w/ Installation Hardware
• Grey caliper finish with rust preventative coating
• Cast iron caliper body with steel piston
• Single 57 mm piston design
• Bracket included for the listed application
• Bleeder screw included
• Caliper slides and dust boots included
• Banjo inlet fitting with M10-1.0 inlet thread
• Brake pad and caliper hardware included; pads not included

Product Details

This Nugeon brake caliper, part number 99-01864B, is built for the front right side of the 2017-2020 Hyundai Elantra and uses a Mando-style caliper design with a 57 mm piston. The remanufactured cast iron housing, rust preventative finish, dust boots, slides, and included bracket support a service-ready replacement for worn or sticking brake calipers. The unit uses a banjo inlet fitting and includes the bleeder screw for brake system service.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured hydraulic brake components with the mounting and service-related pieces needed for the listed application. For shoppers searching for a Hyundai Elantra front right brake caliper, Elantra brake caliper replacement, or Nugeon 99-01864B, this part matches the confirmed fitment shown here.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Brake drag caused by a sticking caliper piston
• Uneven braking from a worn front right caliper
• Brake fluid seepage at the caliper body or bleeder area
• Corrosion on the caliper housing or bracket
• Noisy or inconsistent brake operation from worn caliper hardware

Installation Notes

Verify the front right position and confirm the banjo inlet, M10-1.0 thread size, and bracket style before installation. Transfer or replace brake pads as needed, since pads are not included. Bleed the brake system after installation and inspect all fittings, washers, and hardware for proper sealing and torque.

Quality Assurance

This remanufactured caliper is built with a rust preventative finish, dust boots, included slides, and a bleeder screw for serviceability. It is intended as a direct replacement for the listed Hyundai Elantra applications and should be matched to the vehicle’s brake configuration before installation.