Nugeon 99-01905B Disc Brake Caliper - Front Left

Front Left Reman Brake Caliper

The Nugeon 99-01905B is a remanufactured disc brake caliper for front left applications on select Honda and Isuzu vehicles. It is built with a cast iron housing, grey rust-preventative finish, and a 60 mm steel piston for direct brake service replacement.

This Reman Caliper w/ Installation Hardware product line focuses on service-ready brake hydraulics with the key mounting and sealing components needed for the caliper assembly. The Nugeon 99-01905B is a practical choice for restoring braking performance on vehicles such as the Isuzu Pickup, Isuzu Rodeo, Isuzu Amigo, Isuzu Trooper, and Honda Passport.

Key Features

• Remanufactured disc brake caliper for front left placement
• Cast iron housing with rust-preventative grey finish
• 60 mm steel piston with dust boots included
• Bleeder screw included with M7-1.0 thread size
• Bracket included for listed applications
• Caliper slides included
• Banjo bolt inlet fitting with M10-1.0 inlet port thread
• Brake pad installation hardware and copper crush washers included where applicable

Detailed Description

Nugeon 99-01905B is a reman brake caliper engineered for front left brake service on 1987-1995 Isuzu Trooper, 1988-1995 Isuzu Pickup, 1988-1991 Isuzu Trooper, 1989-1993 Isuzu Amigo, 1991-1995 Isuzu Rodeo, 1994 Isuzu Amigo, and 1994-1995 Honda Passport applications. It uses a single 60 mm steel piston, cast iron construction, and a banjo-bolt inlet connection to match the original brake system layout on the listed vehicles. Part number 99-01905B is also a useful reference when sourcing the correct remanufactured front left caliper for these platforms.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Leaking caliper housing or piston seal failure
• Uneven front brake pad wear on the left side
• Sticking or seized caliper piston movement
• Corrosion on the original caliper body or slides
• Brake pull caused by a worn front left caliper assembly

Installation Notes and Tips

Verify front left fitment against the vehicle’s brake configuration before installation. This caliper uses a banjo bolt inlet and M10-1.0 inlet thread, with an M7-1.0 bleeder screw thread. Inspect brake hoses, pads, and mounting surfaces during service, and confirm proper brake bleeding after installation. Part number 99-01905B should be matched to the exact year, make, model, and position listed for the vehicle.

Quality Assurance

This remanufactured caliper is built with a rust-preventative finish, dust boots, slides, and a replacement bleeder screw to support brake system service on the listed Honda and Isuzu applications. Nugeon 99-01905B is intended for direct replacement use on the confirmed fitments shown above.