Nugeon 99-02000A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Mazda 3

Nugeon 99-02000A is a remanufactured disc brake caliper with installation hardware for the rear right position on select 2014-2016 Mazda 3 and Mazda 3 Sport models. It is built for direct replacement service with the correct bracket, bleeder screw, slides, dust boots, and brake pad installation hardware where applicable.

Key Features

• Fits 2014-2016 Mazda 3, rear right
• Fits 2014-2016 Mazda 3 Sport, rear right
• Remanufactured disc brake caliper with bracket included
• Grey cast iron housing with rust preventative finish
• Banjo inlet fitting with M10-1.0 inlet thread size
• Bleeder screw included with M10-1.0 x 28 thread
• Caliper slides, dust boots, and hardware included
• Single-piston design with 36 mm piston diameter

Product Details

The Nugeon Reman Caliper w/ Installation Hardware, part number 99-02000A, is a rear right disc brake caliper engineered for Mazda 3 brake service. It uses a cast iron housing, steel piston, and a rust preventative finish to support dependable braking performance in a direct-fit replacement format. The included bracket and hardware package simplify service on the rear brake assembly, while the banjo inlet and M10-1.0 thread specifications match the listed application.

This part number 99-02000A is listed for 2014-2016 Mazda 3 and 2014-2016 Mazda 3 Sport rear right applications, including vehicles supplied with a mounting bracket and Japan-built variants where noted. Nugeon 99-02000A is a practical choice when replacing a worn or sticking rear brake caliper on these Mazda models.

Common Problems This Part Can Address

• Brake drag from a sticking rear caliper piston or slide
• Uneven rear brake wear caused by caliper binding
• Brake fluid leakage at the caliper or bleeder area
• Corrosion on the caliper body or hardware
• Noisy or inconsistent rear braking from worn caliper components

Installation Notes and Tips

Verify rear right fitment against the vehicle’s brake configuration before installation. Inspect the banjo bolt sealing surfaces and use new copper crush washers where applicable. Bleed the brake system after installation, confirm proper slide movement, and check for leaks before returning the vehicle to service. Part number 99-02000A should be matched to the listed Mazda 3 and Mazda 3 Sport rear right applications only.

Quality Assurance

This Nugeon remanufactured caliper is rebuilt for service replacement use and supplied with the listed components for the application. The remanufactured construction, cast iron housing, and rust preventative finish support consistent fit and function for the specified Mazda rear brake applications.