Nugeon 99-02329A Disc Brake Caliper - Front Right

Front Right Brake Caliper for BMW 740i and 740iL

Nugeon 99-02329A is a remanufactured disc brake caliper for the front right position on select BMW 740i and BMW 740iL models. It is built with a cast iron housing, grey rust-preventative finish, and the mounting bracket and slides needed for the listed applications.

Key Features

• Remanufactured front right disc brake caliper
• Fits 1994-2001 BMW 740i and 740iL applications listed below
• Cast iron housing with grey rust-preventative finish
• Single 60 mm steel piston
• Bleeder screw included
• Bracket included for the specified fitments
• Dust boots included
• Caliper slides included
• Inlet thread size: M10-1.0
• Bleeder thread size: M7-1.0

Product Details

The Nugeon 99-02329A reman caliper is a direct-fit brake hydraulics replacement for BMW 740i and BMW 740iL front right applications. The remanufactured design uses a steel piston and cast iron body for consistent brake pressure transfer, while the included bracket and slides support proper caliper mounting on the listed vehicles. This part number, 99-02329A, is a practical choice when replacing a worn, sticking, or leaking front brake caliper on the BMW 740i platform.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 1997-2001 BMW 740i, front right; supplied with mounting bracket; reman caliper with installation hardware
• Fits 1995 BMW 740i, front right; supplied with mounting bracket; reman caliper with installation hardware
• Fits 1995-2001 BMW 740iL, front right; supplied with mounting bracket; reman caliper with installation hardware
• Fits 1994 BMW 740i, front right; supplied with mounting bracket; from 05/94; reman caliper with installation hardware
• Fits 1994 BMW 740iL, front right; supplied with mounting bracket; from 05/94; reman caliper with installation hardware

Common Repair Uses

• Restores braking performance after caliper seizure or piston sticking
• Addresses brake fluid leakage at the caliper body or bleeder area
• Replaces a corroded or damaged front right caliper assembly
• Helps correct uneven braking or pull during stops
• Supports brake service on BMW 740i and BMW 740iL front axle repairs

Installation Notes

Verify the front right position and confirm the inlet port thread size is M10-1.0 before installation. The caliper includes a bleeder screw and bracket, and the package contents note brake pad installation hardware with banjo bolt and copper crush washers where applicable. Pads are not included. Always inspect brake hoses, pads, rotors, and mounting surfaces during service, and bleed the hydraulic system after installation.

Quality Assurance

Nugeon remanufactured brake calipers are rebuilt for brake service applications using a rust-preventative finish and replacement wear components such as dust boots and slides where specified. Part number 99-02329A is cataloged for the listed BMW 740i and 740iL front right fitments.