Nugeon 99-02332A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for BMW 735i and 735iL

Nugeon 99-02332A is a remanufactured rear right disc brake caliper for select BMW 7 Series applications. It is built with a cast iron housing, grey rust-preventative finish, and supplied with a mounting bracket for the listed BMW 735i and 735iL fitments.

This Nugeon reman caliper w/ installation hardware is a direct-fit brake hydraulics replacement for 1987-1992 BMW 735i and 1988-1992 BMW 735iL rear right positions. The 99-02332A part number is a practical match for drivers servicing the rear brake system on these vehicles.

Key Features

• Remanufactured disc brake caliper for rear right installation
• Cast iron housing with rust-preventative grey finish
• Bracket included for the listed applications
• Bleeder screw included with M7-1.0 thread
• Steel piston with 38 mm outside diameter
• Caliper slides and dust boots included
• Inlet thread size: M10-1.0
• Package contents include brake pad installation hardware with banjo bolt and copper crush washers where applicable

Product Details

Nugeon’s Reman Caliper w/ Installation Hardware line focuses on replacement brake hydraulics built for serviceable OE-style fitment. Part number 99-02332A is a rear right disc brake caliper with a single 38 mm steel piston, bracket included, and a plug-style inlet fitting. It is finished in grey with rust prevention treatment and includes the bleeder screw, dust boots, and caliper slides needed for the caliper assembly.

Fits 1987-1992 BMW 735i, rear right. Fits 1988-1992 BMW 735iL, rear right. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Can Address

• Rear brake drag caused by a sticking caliper piston or slide hardware
• Uneven rear braking from a worn or corroded caliper assembly
• Brake fluid leakage at the caliper body or bleeder area
• Poor pedal response related to a failing rear hydraulic component
• Brake noise tied to worn caliper hardware or damaged dust boots

Installation Notes and Tips

Verify rear right placement, inlet thread size, and bracket configuration before installation. Transfer or connect brake lines carefully, use the correct banjo bolt and copper crush washers where applicable, and bleed the brake system after installation to remove air from the hydraulic circuit. Inspect pads, rotors, and hoses at the same time to confirm the repair addresses the full rear brake assembly.

Quality Assurance

This Nugeon remanufactured caliper is built as a replacement brake component for the listed BMW applications and includes the specified hardware and service features shown above.