Nugeon 99-02333A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for BMW 740i and 740iL

Nugeon 99-02333A is a remanufactured rear right disc brake caliper for select BMW 740i and BMW 740iL models. It is supplied with a mounting bracket and installation hardware details noted for the application, making it a direct-fit brake hydraulics replacement for the listed vehicles.

Key Features

• Remanufactured rear right disc brake caliper
• Fits select 1994-2001 BMW 740i and 740iL applications
• Grey caliper with rust preventative finish
• Cast iron housing with steel piston
• Includes bleeder screw, dust boots, caliper slides, and bracket
• 40 mm (2 in.) piston diameter
• M10-1.0 inlet thread size and M7-1.0 bleeder thread size
• Part number 99-02333A

Product Details

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics built for direct replacement service. This 99-02333A caliper is engineered for the rear right position on BMW 740i and BMW 740iL models listed below, with the correct bracket configuration and hydraulic connections for the application. The cast iron body, steel piston, dust boots, and rust preventative finish support dependable brake service in a replacement caliper assembly.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Vehicle Fitment

• Fits 1997-2001 BMW 740i, rear right. Supplied w/ Mounting Bracket; Reman Caliper w/ Installation Hardware.
• Fits 1995 BMW 740i, rear right. Supplied w/ Mounting Bracket; Reman Caliper w/ Installation Hardware.
• Fits 1995-2001 BMW 740iL, rear right. Supplied w/ Mounting Bracket; Reman Caliper w/ Installation Hardware.
• Fits 1994 BMW 740i, rear right. Supplied w/ Mounting Bracket; From 05/94; Reman Caliper w/ Installation Hardware.
• Fits 1994 BMW 740iL, rear right. Supplied w/ Mounting Bracket; From 05/94; Reman Caliper w/ Installation Hardware.

Installation Notes and Tips

• Verify rear right position and confirm the vehicle is one of the listed BMW 740i or BMW 740iL applications before installation.
• Check inlet thread size, bleeder thread size, and bracket casting numbers against the original caliper.
• Inspect brake hoses, pads, and rotor condition during caliper replacement.
• Bleed the brake system thoroughly after installation to remove air from the hydraulic circuit.
• Use the correct banjo bolt and copper crush washers where applicable.

Quality Assurance

This remanufactured caliper is built as a replacement brake hydraulics component for the specified BMW applications. Its remanufactured construction, cast iron housing, steel piston, included bleeder screw, dust boots, caliper slides, and bracket support consistent service fitment for the listed vehicles.