Nugeon 99-07656A Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Mitsubishi Diamante

Nugeon 99-07656A is a remanufactured disc brake caliper for the rear left position on 1993-1995 Mitsubishi Diamante models. This reman caliper with installation hardware is built for direct replacement service and includes the bracket, slides, dust boots, and bleeder screw for a cleaner brake repair.

Key Features

• Fits 1993-1995 Mitsubishi Diamante, rear left
• Remanufactured disc brake caliper with grey rust-preventative finish
• Cast iron housing with steel piston for brake system service
• Bracket included for the specified application
• Caliper slides and dust boots included
• Bleeder screw included; M7-1.0 bleeder thread
• M10-1.0 inlet port thread with tube seat fitting
• Part number 99-07656A for catalog and fitment lookup

Product Details

The Nugeon Reman Caliper w/ Installation Hardware line is focused on replacement brake hydraulics built for serviceability and fitment accuracy. Part number 99-07656A is a rear left disc brake caliper for Mitsubishi Diamante applications from 1993 through 1995, with the mounting bracket supplied for the listed vehicle fitment. The caliper uses a single 38 mm steel piston, cast iron housing, and a rust-preventative finish to support brake system restoration on the rear axle.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Restoring rear brake clamping force on a Mitsubishi Diamante
• Replacing a sticking or seized rear left caliper
• Addressing brake fluid leakage at the caliper body or bleeder area
• Correcting uneven rear brake wear caused by caliper drag
• Repairing corrosion-related brake hardware wear on the rear axle

Installation Notes

Verify rear left placement before installation and confirm the inlet port, bleeder thread, and bracket style match the original brake setup. Transfer or replace any vehicle-specific brake pad hardware as needed, and bleed the hydraulic system after installation to remove air from the circuit. Inspect the rotor, pads, and brake hose condition during caliper replacement to complete the repair properly.

Quality Assurance

This remanufactured caliper is built with a rust-preventative finish, dust boots, and included slides to support dependable brake service on the specified Mitsubishi Diamante applications. Part number 99-07656A is cataloged for direct identification during brake hydraulic replacement.