Nugeon 99-09119B Disc Brake Caliper - Rear Left

Reman Rear Left Caliper for Saab 9-3

This Nugeon remanufactured disc brake caliper is built for the rear left position on 2003-2007 Saab 9-3 models. Part number 99-09119B is supplied with a mounting bracket and installation hardware details listed below, making it a direct-service replacement for brake hydraulic repair work.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake calipers that restore proper hydraulic function while matching the original mounting and connection points. For Saab 9-3 rear brake service, 99-09119B provides the correct bracketed caliper configuration for the specified application.

• Fits 2003-2007 Saab 9-3, rear left
• Remanufactured disc brake caliper with aluminum casting
• Grey finish with rust preventative coating
• Bracket included for the specified application
• Single 40 mm steel piston
• Bleeder screw included; M10-1.0 bleeder thread
• Banjo bolt inlet fitting with M12-1.0 inlet thread
• Dust boots and caliper slides included
• Hardware included; brake pad installation hardware, banjo bolt, and copper crush washers where applicable

Use this caliper when servicing the rear left brake corner on a Saab 9-3 and you need a remanufactured replacement that matches the original hydraulic and mounting layout. The 99-09119B caliper is identified by housing cast numbers 991 and 957, with bracket cast number 634, which helps confirm the correct service part during brake repair. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues It Can Address

• Leaking or sticking rear brake caliper
• Uneven rear brake pad wear on the left side
• Corrosion on the caliper body or piston area
• Soft or inconsistent rear brake pedal response caused by hydraulic caliper wear
• Brake drag from worn slides, seals, or piston components

Installation Notes and Tips

Verify the rear left position and confirm the inlet and bleeder thread sizes before installation. Transfer or replace brake fluid as needed, bleed the brake system after installation, and inspect the banjo connection and copper crush washers for proper sealing. Confirm wheel clearance and pad fitment before returning the vehicle to service.

Quality Assurance

This Nugeon remanufactured caliper is rebuilt for brake service applications and finished with rust preventative coating to support long-term corrosion resistance in normal driving conditions. Confirm all casting numbers, thread sizes, and position details against the vehicle before installation.