Nugeon 99-17327A Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Seville

This Nugeon remanufactured disc brake caliper is built for the rear left position on 2000-2003 Cadillac Seville models. Part number 99-17327A is supplied with a mounting bracket and installation hardware details listed below, making it a direct replacement option for brake service on the Cadillac Seville rear left corner.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics with application-specific fitment and included service components where applicable. For this 99-17327A caliper, the grey cast iron housing, rust preventative finish, steel piston, dust boots, bleeder screw, slides, and bracket support a straightforward brake repair on the rear left side.

• Fits 2000-2003 Cadillac Seville, rear left
• Remanufactured disc brake caliper with bracket included
• Grey cast iron housing with rust preventative finish
• Steel piston with dust boots and caliper slides included
• Bleeder screw included; inlet fitting uses a banjo bolt
• Brake pad installation hardware and copper crush washers included where applicable
• Part number 99-17327A for application-specific ordering

Built around a 38 mm piston and M10-1.5 thread specifications, this rear left caliper is matched to the listed Cadillac Seville applications and the cast numbers AD38P, 3807, 11, and 15. If you are replacing a worn or sticking rear brake caliper on a 2000-2003 Cadillac Seville, 99-17327A provides the correct rear left service configuration with the bracket already accounted for in the fitment.

Common Brake Issues This Part Can Address

• Uneven rear braking caused by a sticking caliper piston
• Brake drag from worn internal seals or damaged dust boots
• Soft or inconsistent rear brake response from a failing hydraulic caliper
• Noise or vibration related to worn caliper slides
• Brake fluid seepage at the bleeder or inlet connection

Installation Notes

Verify rear left fitment before installation on 2000-2003 Cadillac Seville models. Confirm banjo bolt connection, M10-1.5 inlet thread size, and M10-1.5 bleeder thread size during brake service. Transfer or replace pads as needed, and follow proper bleeding procedures after installation to remove air from the hydraulic system. Part number 99-17327A should be matched to the vehicle’s rear left brake position only.

Quality Assurance

This Nugeon remanufactured caliper is rebuilt for brake hydraulic service with application-specific hardware details and corrosion-resistant finishing. Part number 99-17327A is listed for the rear left 2000-2003 Cadillac Seville application and is identified by the supplied bracket and caliper specifications for accurate replacement selection.