Nugeon 99-18040B Disc Brake Caliper - Front Right

Front Right Reman Brake Caliper

Nugeon 99-18040B is a remanufactured front right disc brake caliper with installation hardware details specified for the listed applications. It is built for the Ford Edge, Lincoln Nautilus, and Lincoln MKX front right positions where a direct brake hydraulic replacement is needed.

The Nugeon Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics with application-specific fitment and included service components where applicable. Part number 99-18040B follows that approach with a cast iron housing, grey rust-preventative finish, and bracket included for the confirmed vehicle applications.

• Remanufactured front right disc brake caliper
• Fits 2015-2020 Ford Edge, front right
• Fits 2016-2018 Lincoln MKX, front right
• Fits 2019-2020 Lincoln Nautilus, front right
• Fits 2021 Ford Edge, front right, to 02/08/2021
• Fits 2021 Lincoln Nautilus, front right, to 02/08/2021
• Cast iron housing with rust-preventative finish
• 44 mm steel pistons with dust boots and slides included
• Banjo bolt inlet fitting with M10-1.0 thread size
• Bleeder screw included

Brake Service Details

This caliper is intended for front right brake service on the Ford Edge, Lincoln Nautilus, and Lincoln MKX listed above. It uses a 2-inch (44 mm) piston design and includes the bracket, caliper slides, dust boots, and bleeder screw for the specified applications. Part number 99-18040B is a direct reference for ordering and catalog verification.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems It Can Address

• Sticking or seized front right brake caliper
• Uneven pad wear on the front axle
• Brake fluid leakage at the caliper body or bleeder area
• Reduced braking response from worn hydraulic components
• Corrosion-related caliper movement issues

Installation Notes

Verify front right fitment by year, make, model, and the listed cutoff date before installation. Confirm the banjo bolt inlet, M10-1.0 thread sizes, and bracket configuration match the original part. Brake pad hardware is listed in the package contents where applicable, but pads are not included.

Bleeding the brake system after installation is required whenever the hydraulic circuit is opened. Inspect the rotor, pads, brake hose, and mounting points before returning the vehicle to service.

Quality Assurance

Nugeon remanufactured brake calipers are built for application-specific replacement use with inspected cast iron housings, serviceable hardware, and corrosion-resistant finishing. Part number 99-18040B is cataloged for the confirmed Ford and Lincoln front right applications listed above.