Nugeon 99P00569A Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Nissan and INFINITI

This remanufactured Nugeon disc brake caliper is built for rear left applications on select Nissan and INFINITI vehicles. Part number 99P00569A is a direct-fit brake hydraulics replacement with a 43 mm steel piston, mounting bracket, bleeder screw, slides, dust boots, and hardware included where applicable.

Nugeon TechShield 360 (tm) is the product line used on this caliper, with a rust-preventative finish and grey coating for added corrosion resistance in everyday driving conditions. It is a practical choice for drivers servicing rear brake caliper wear on the Nissan Murano, Nissan Quest, Nissan 350Z, and INFINITI G35.

Key Features

• Fits rear left brake applications on select 2003-2009 Nissan and INFINITI models
• Remanufactured cast iron caliper with a 43 mm steel piston
• Supplied with mounting bracket and caliper slides
• Includes bleeder screw and dust boots
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Rust-preventative finish for corrosion resistance
• TechShield 360 (tm) product line

Detailed Description

Part number 99P00569A is a rear left disc brake caliper engineered for select Nissan Murano, Nissan Quest, Nissan 350Z, and INFINITI G35 applications. It uses a single 43 mm steel piston in a cast iron housing and comes remanufactured for brake system service where the original caliper has seized, leaked, or shown uneven pad wear. The caliper includes a bracket, slides, bleeder screw, dust boots, and brake pad installation hardware with banjo bolt and copper crush washers where applicable.

The TechShield 360 (tm) line focuses on corrosion protection through a rust-preventative finish, making this caliper a solid replacement for rear brake hydraulics service. If you are replacing a rear left caliper on a 2003-2007 Nissan Murano, 2004-2009 Nissan Quest, 2003-2005 Nissan 350Z, or 2003-2005 INFINITI G35, this unit matches the listed fitment and mounting configuration. Part number 99P00569A is also a useful reference when ordering the correct rear left caliper for these vehicles.

What It Helps Fix

• Rear brake drag caused by a sticking caliper piston
• Brake fluid leakage at the caliper or bleeder area
• Uneven rear pad wear from worn slides or caliper hardware
• Corrosion-related caliper seizure on older vehicles
• Soft or inconsistent rear braking from a failing hydraulic caliper

Installation Notes and Tips

Verify rear left position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm rotor condition, pad wear, and brake hose condition during service to avoid repeat brake issues. Use the vehicle-specific fitment listing for 2003-2009 Nissan Quest, 2003-2007 Nissan Murano, 2003-2005 Nissan 350Z, and 2003-2005 INFINITI G35 rear left applications.

Quality Assurance

This remanufactured caliper is built under Nugeon TechShield 360 (tm) standards with a rust-preventative finish and included service components listed above. Part number 99P00569A is intended for direct replacement use in the confirmed rear left applications shown here.