Nugeon 99P00591B Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Nissan

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear left replacement built for select Nissan Sentra and Nissan Juke applications. Part number 99P00591B is supplied with a mounting bracket and includes a bleeder screw, caliper slides, dust boots, and hardware for the listed applications.

Key Features

• Remanufactured cast iron disc brake caliper with grey rust-preventative finish
• TechShield 360 product line for corrosion-focused brake hydraulic replacement
• Rear left position for select Nissan Sentra and Nissan Juke models
• Includes bracket, bleeder screw, caliper slides, dust boots, and hardware
• Single-piston design with 35 mm steel piston
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw thread: M7-1.0

Product Details

Nugeon part number 99P00591B is a disc brake caliper for the rear left side of select Nissan brake systems. The TechShield 360 line focuses on corrosion-resistant protection for brake hydraulic components, while the remanufactured cast iron housing and rust-preventative finish support dependable service in everyday driving conditions. This caliper is configured with a single steel piston, integrated bracket, and the listed bleeder and inlet thread specifications for direct application matching.

Compatible With: 2007-2015 Nissan Sentra, rear left; 2016 Nissan Sentra, rear left, to 06/2016; 2017-2019 Nissan Sentra, rear left; 2011-2017 Nissan Juke, rear left. Part number 99P00591B is also a useful reference when verifying the correct rear left caliper for these Nissan applications.

Common Issues This Part Addresses

• Brake fluid leakage at the caliper housing or bleeder area
• Uneven rear brake pad wear caused by sticking caliper movement
• Reduced braking response from a seized or corroded piston assembly
• Noise or drag related to worn caliper slides or damaged dust boots
• Fitment problems when replacing a rear left caliper on the listed Nissan models

Installation Notes and Tips

Verify rear left fitment by year, model, and the 2016 Sentra build cutoff before installation. Confirm the banjo bolt connection, inlet thread size, and bleeder thread size match the vehicle brake line and service parts. Transfer or replace brake pads as needed, and bleed the hydraulic system after installation to remove air from the circuit. Inspect the bracket mounting points, slide movement, and rotor condition before returning the vehicle to service.

Quality Assurance

Nugeon TechShield 360 brake components are built as remanufactured replacements for brake hydraulic service, with corrosion-focused finishing and application-specific hardware details for the listed vehicles. Part number 99P00591B is specified for select Nissan Sentra and Nissan Juke rear left applications.