Nugeon 99P00592A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Nissan and Infiniti

Nugeon TechShield 360 (tm) disc brake caliper Part Number 99P00592A is a remanufactured front right brake hydraulic component for select Nissan and Infiniti applications. It is built with a cast iron housing, phenolic pistons, and a rust preventative finish to support consistent braking performance and corrosion resistance.

Compatible With 2006-2015 Nissan Armada, front right; 2007-2013 Infiniti QX56, front right; 2008-2015 Nissan TITAN, front right; 2014-2024 Infiniti QX80, front right; 2017-2024 Nissan Armada, front right; and 2017-2024 Nissan TITAN, front right. Part number 99P00592A is supplied with a mounting bracket and brake pad installation hardware where applicable.

Key Features

• Remanufactured disc brake caliper for the front right position
• TechShield 360 (tm) product line for corrosion-focused brake hydraulic protection
• Cast iron housing with grey rust preventative finish
• Dual phenolic pistons with 2 in. / 51 mm outside diameter
• Bleeder screw included
• Bracket included with caliper slides and dust boots
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Brake pad installation hardware included where applicable

Product Details

Nugeon 99P00592A is a front right disc brake caliper engineered for Nissan Armada, Nissan TITAN, Infiniti QX56, and Infiniti QX80 applications listed in the fitment data. The TechShield 360 (tm) line focuses on brake hydraulic protection, and this unit uses a rust preventative finish, dust boots, and included slides to support smooth caliper movement. The caliper is configured with a banjo bolt inlet, M10-1.0 inlet thread size, and a bleeder screw with M10-1.0 thread specification.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Uneven front brake pad wear on the right side
• Brake fluid seepage at the caliper body or bleeder area
• Sticking or restricted caliper piston movement
• Corrosion on the caliper housing or slide surfaces
• Reduced braking response from a worn hydraulic caliper assembly

Installation Notes and Tips

Verify the front right position, bracket style, inlet fitting type, and thread sizes before installation. Transfer or replace brake pads as needed, and follow the vehicle service procedure for bleeding the brake system after caliper replacement. Confirm that the banjo bolt and copper crush washers are correct for the application where applicable.

Quality Assurance

This remanufactured caliper is built with a cast iron housing, phenolic pistons, dust boots, and a rust preventative finish to support dependable brake service on compatible Nissan Armada, Nissan TITAN, Infiniti QX56, and Infiniti QX80 vehicles. Part Number 99P00592A is prepared for direct replacement use in the listed front right applications.