Nugeon 99P00592B Disc Brake Caliper - Front Left

Front Left Brake Caliper for Nissan and Infiniti

Nugeon TechShield 360 (tm) 99P00592B is a remanufactured front left disc brake caliper built for select Nissan Armada, Nissan TITAN, INFINITI QX56, and INFINITI QX80 applications. It includes the mounting bracket and uses a cast iron housing with a rust preventative finish for service-ready replacement on the front brake system.

TechShield 360 (tm) identifies Nugeon’s product line for brake hydraulics built around corrosion resistance and application-specific remanufacturing. This caliper uses a phenolic piston, includes the bleeder screw, dust boots, slides, and hardware, and is configured with a banjo bolt inlet for the listed fitments.

Key Features

• Part number 99P00592B
• Front left disc brake caliper with bracket included
• Remanufactured cast iron housing with grey rust preventative finish
• Phenolic piston design with 2-inch piston diameter
• Bleeder screw included
• Dust boots and caliper slides included
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Brake pad installation hardware included where applicable

Detailed Description

This Nugeon brake caliper is built for direct replacement on the front left side of select Nissan Armada, Nissan TITAN, INFINITI QX56, and INFINITI QX80 models. The remanufactured design restores the caliper body, bracket, and hydraulic function for vehicles that need a replacement front brake hydraulics component with the correct mounting and inlet configuration. Part number 99P00592B is listed with cast numbers 5112 on both the bracket and housing.

The TechShield 360 (tm) line focuses on corrosion protection and service-ready brake hardware. This unit uses a phenolic piston, includes a bleeder screw, and comes with dust boots and slides to support proper caliper operation. It is a practical choice for drivers searching for a front left brake caliper for 2006-2015 Nissan Armada, 2008-2015 Nissan TITAN, 2007-2013 INFINITI QX56, or 2014-2024 INFINITI QX80 applications.

What This Part Helps Address

• Brake drag or uneven pad wear from a sticking front left caliper
• Hydraulic leakage at the caliper body or bleeder area
• Corrosion on the caliper housing or bracket
• Reduced braking response caused by worn piston or slide components
• Noisy or inconsistent front brake operation after caliper wear

Installation Notes and Tips

Verify the vehicle’s front left brake configuration, inlet thread size, and banjo bolt connection before installation. This caliper is supplied with the bracket and uses the listed M10-1.0 inlet thread and bleeder screw specification. Brake pad installation hardware is included where applicable, but pads are not included.

For best results, inspect brake hoses, pads, rotors, and mounting points during replacement. Bleed the brake system thoroughly after installation and confirm proper caliper movement before returning the vehicle to service.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are built for application-specific replacement in brake hydraulics service. Part number 99P00592B is matched to the listed Nissan and Infiniti front left applications for proper fitment.