Nugeon 99P00835A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Hyundai Elantra

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear right replacement for 2007-2009 Hyundai Elantra applications. Part number 99P00835A is built for direct brake hydraulics service with the correct bracket, bleeder screw, slides, dust boots, and rust-preventative finish.

Key Features

• Fits 2007-2009 Hyundai Elantra, rear right
• Remanufactured cast iron disc brake caliper
• TechShield 360 product line with rust-preventative grey finish
• Includes bracket, bleeder screw, caliper slides, dust boots, and hardware
• Single-piston design with 30 mm steel piston
• Banjo bolt inlet fitting with M10-1.0 thread size
• Bleeder screw thread: M10-1.0 x 28

Detailed Description

Nugeon 99P00835A is a rear right disc brake caliper for the 2007, 2008, and 2009 Hyundai Elantra. It is part of the TechShield 360 line, which focuses on corrosion resistance and service-ready brake hydraulics components. The caliper is remanufactured from cast iron and finished in grey with a rust-preventative coating to support long-term durability in everyday braking conditions.

This caliper uses a single 30 mm steel piston and includes the bracket and slides needed for the specified rear right application. The inlet uses a banjo bolt connection with M10-1.0 threading, and the bleeder screw is included for brake bleeding during service. Part number 99P00835A is a direct-fit brake caliper choice for Hyundai Elantra rear brake repair where the original unit has seized, leaked, or worn unevenly.

What It Helps Fix

• Brake fluid leakage at the caliper body or bleeder area
• Sticking or seized rear brake piston movement
• Uneven rear brake pad wear on the Hyundai Elantra
• Reduced braking response from a worn hydraulic caliper
• Corrosion-related caliper performance issues

Installation Notes and Tips

Verify rear right position, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm rotor condition and inspect brake hoses, mounting points, and pad hardware during service. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Quality Assurance

Nugeon TechShield 360 brake components are remanufactured for brake service applications and built with corrosion-resistant finishing details to support consistent fit and function in the specified vehicle application.