Nugeon 99P00835B Disc Brake Caliper - Rear Left

Rear Left Disc Brake Caliper for Hyundai Elantra

This Nugeon TechShield 360 disc brake caliper is a remanufactured rear left replacement for 2007-2009 Hyundai Elantra models. Built with a cast iron housing, grey rust-preventative finish, and a single 30 mm steel piston, it is made for direct hydraulic brake service on the rear left corner.

The Nugeon TechShield 360 (tm) line focuses on corrosion resistance and service-ready brake hydraulics. For this application, the caliper includes a mounting bracket, slides, dust boots, and a bleeder screw, along with brake pad installation hardware where applicable.

• Fits 2007-2009 Hyundai Elantra, rear left
• Remanufactured disc brake caliper with TechShield 360 (tm) protection
• Cast iron housing with rust-preventative grey finish
• Single 30 mm steel piston for rear brake hydraulic operation
• Includes bracket, slides, dust boots, hardware, and bleeder screw
• Banjo bolt inlet with M10-1.0 inlet thread size

Detailed Product Overview

Part number 99P00835B is a rear left disc brake caliper engineered for the 2007-2009 Hyundai Elantra. It uses a banjo bolt inlet fitting, M10-1.0 inlet thread size, and an M10-1.0 bleeder screw thread, making it a direct-fit hydraulic replacement for the listed application. The housing cast number is BC140117.

Part number 99P00835B is also identified by Nugeon’s TechShield 360 (tm) product line, which adds a rust-preventative finish to help maintain caliper appearance and serviceability. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Caliper Can Address

• Rear left caliper sticking or uneven brake release
• Brake fluid leakage at the caliper body or bleeder area
• Corrosion on the caliper housing or slide surfaces
• Uneven rear brake pad wear caused by caliper drag
• Reduced braking performance from a worn hydraulic piston assembly

Installation Notes and Tips

Verify the rear left position and confirm the banjo bolt inlet connection before installation. Transfer or replace brake pads as needed, and inspect the brake hose, copper crush washers, and mounting surfaces for wear or contamination. Bleed the brake system after installation to remove air from the hydraulic circuit.

Quality Assurance

This remanufactured Nugeon caliper is built with a cast iron body, steel piston, dust boots, and included service hardware for the specified Hyundai Elantra applications. It is prepared for brake system replacement on 2007-2009 Hyundai Elantra rear left positions.