Nugeon 99P00837A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Hyundai Veracruz

Nugeon TechShield 360 (tm) part number 99P00837A is a remanufactured disc brake caliper for the rear right position on select Hyundai Veracruz models. It is built with a cast iron housing, grey rust-preventative finish, and included bracket, making it a direct-fit brake hydraulics replacement for the specified application.

Compatible with 2007-2012 Hyundai Veracruz rear right applications, this caliper includes a steel piston, dust boots, slides, and a bleeder screw for service-ready installation. The TechShield 360 (tm) product line focuses on corrosion resistance and consistent brake system function for everyday driving conditions.

Key Features

• Fits 2007-2012 Hyundai Veracruz, rear right
• Remanufactured disc brake caliper from Nugeon
• TechShield 360 (tm) finish with rust preventative coating
• Cast iron housing with grey finish
• Includes bracket, slides, dust boots, and bleeder screw
• Steel piston with 41 mm outside diameter
• Banjo bolt inlet fitting with M10-1.0 inlet thread
• Bleeder screw thread: M10-1.0 x 28
• Part number 99P00837A

Product Details

This Nugeon brake caliper is engineered for the rear right side of the Hyundai Veracruz and is supplied with the mounting bracket required for the listed application. The caliper uses a single steel piston and a banjo bolt inlet connection, with dust boots and slides included to support proper caliper movement and brake fluid sealing. Part number 99P00837A is a practical replacement for worn, sticking, or leaking rear brake calipers on the 2007-2012 Hyundai Veracruz.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues This Part Can Address

• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear braking caused by a sticking piston
• Dragging brake pads from seized or corroded caliper components
• Reduced braking performance from a worn rear right caliper
• Noise or vibration related to caliper wear or corrosion

Installation Notes and Tips

Verify rear right fitment before installation on your Hyundai Veracruz. Transfer or replace brake pads as needed, and inspect the brake hose, banjo bolt sealing surfaces, and copper crush washers during service. Bleed the brake system after installation to remove air and restore pedal feel. Confirm that the caliper bracket, slides, and piston movement operate smoothly before returning the vehicle to service.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured calipers are finished with a rust-preventative coating and built with service-focused components for the listed brake application. Part number 99P00837A is intended for direct replacement use on the specified Hyundai Veracruz rear right position.