Nugeon 99P00854A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Hyundai Sonata

Nugeon TechShield 360 (tm) 99P00854A is a remanufactured disc brake caliper for the rear right position on select Hyundai Sonata models. It is built with a cast iron housing, grey rust-preventative finish, and a 33 mm steel piston for direct brake hydraulic service.

Fits 2008 Hyundai Sonata, rear right, from 01/21/08. Fits 2009-2010 Hyundai Sonata, rear right. The TechShield 360 (tm) product line focuses on corrosion resistance and service-ready brake hydraulics for applications that need dependable fit and function.

Key Features

• Remanufactured disc brake caliper for brake hydraulic replacement
• Rear right fitment for Hyundai Sonata applications
• Supplied with mounting bracket
• Cast iron housing with rust-preventative grey finish
• 33 mm steel piston with dust boots included
• Bleeder screw included; banjo bolt inlet fitting
• Caliper slides and hardware included
• Housing cast number BC140154

Detailed Description

Nugeon 99P00854A is a rear right disc brake caliper engineered for 2008-2010 Hyundai Sonata brake service. It uses a single 33 mm steel piston, a banjo bolt inlet connection, and an M10-1.0 inlet thread size for the specified application. The included bracket and slides support a direct replacement installation where the original caliper assembly is being serviced. This part number, 99P00854A, is a practical match for Hyundai Sonata rear brake repairs that require a remanufactured caliper assembly.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston
• Uneven rear braking from a worn or seized caliper assembly
• Brake fluid leakage at the caliper body or bleeder area
• Corrosion-related caliper binding on the rear right corner
• Reduced brake response from a damaged hydraulic caliper

Installation Notes and Tips

Verify rear right placement before installation and confirm the banjo bolt connection, inlet thread size, and bleeder screw thread match the vehicle’s brake line setup. Transfer or replace brake pads as needed, since pads are not included. Bleed the brake system after installation and inspect for leaks at the banjo fitting and bleeder screw. Confirm the 2008 Hyundai Sonata application from 01/21/08 and the 2009-2010 Hyundai Sonata rear right fitment before ordering.

Quality Assurance

This Nugeon brake caliper is remanufactured and finished with rust-preventative coating for brake service durability. TechShield 360 (tm) identifies the product line used for corrosion-focused brake hydraulic components.