Nugeon 99P00857A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Kia Sportage and Hyundai Tucson

Nugeon TechShield 360 (tm) part number 99P00857A is a remanufactured disc brake caliper for rear right applications. It is built with a cast iron housing, grey rust-preventative finish, and a 34 mm steel piston for direct brake hydraulic service on select Kia Sportage and Hyundai Tucson models.

Key Features

• Fits 2011-2016 Kia Sportage, rear right, supplied with mounting bracket; TechShield 360 (tm)
• Fits 2010-2015 Hyundai Tucson, rear right, supplied with mounting bracket; TechShield 360 (tm)
• Remanufactured disc brake caliper with bracket included
• Cast iron housing with rust-preventative grey finish
• 34 mm steel piston with dust boots included
• Bleeder screw included; M10-1.0 inlet and bleeder thread sizes
• Caliper slides and hardware included
• Banjo bolt inlet fitting type

Product Details

TechShield 360 (tm) is Nugeon’s product line for brake hydraulics protection and service-ready replacement parts. This rear right caliper, part number 99P00857A, is built for select Kia Sportage and Hyundai Tucson vehicles and includes the bracket needed for the listed applications. The remanufactured design uses a cast iron body, steel piston, dust boots, and a rust-preventative finish to support dependable brake operation in everyday driving conditions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues This Caliper Can Address

• Rear brake drag caused by a sticking piston or slide hardware
• Uneven braking from a worn or corroded caliper assembly
• Brake fluid seepage at the caliper body or bleeder area
• Noisy or inconsistent rear brake operation from a failing hydraulic unit
• Reduced braking performance on the rear right corner of the vehicle

Installation Notes and Tips

Verify rear right fitment before installation on 2011-2016 Kia Sportage and 2010-2015 Hyundai Tucson models. Confirm the M10-1.0 inlet and bleeder thread sizes, and match the banjo bolt connection and copper crush washers where applicable. Inspect brake hoses, pads, and rotor condition during service, and bleed the hydraulic system after installation to remove air from the circuit.

Quality Assurance

Nugeon TechShield 360 (tm) remanufactured brake components are prepared for brake hydraulic replacement service with attention to fit, finish, and corrosion resistance. Part number 99P00857A is built for the listed rear right applications and supplied with the bracket, slides, hardware, and bleeder screw specified in the product data.