Nugeon 99P00918B Disc Brake Caliper - Front Right

Front Right Brake Caliper for Accord and CL

Nugeon TechShield 360 (tm) part number 99P00918B is a remanufactured disc brake caliper for the front right position. It is built for direct replacement on select Honda Accord and Acura CL applications, with the bracket included for the listed fitments.

The TechShield 360 (tm) product line focuses on corrosion resistance and service-ready brake hydraulics. This caliper uses a rust preventative finish, cast iron housing, a steel piston, and includes the bleeder screw, dust boots, slides, and hardware listed in the product data.

Key Features

• Remanufactured disc brake caliper for front right brake service
• Fits 1997-1999 Acura CL, front right
• Fits 1993-1997 Honda Accord, front right
• Fits 1990-1993 Honda Accord, front right; Akebono design
• Grey caliper with rust preventative finish
• Cast iron housing with one 57 mm steel piston
• Bracket included for the listed applications
• Bleeder screw included with M10-1.0 thread
• Dust boots and caliper slides included
• Banjo bolt inlet fitting with copper crush washers where applicable

Product Details

Part number 99P00918B is a remanufactured front right disc brake caliper engineered for select Honda Accord and Acura CL vehicles. It uses a single 57 mm piston, M10-1.0 inlet threading, and a banjo bolt inlet fitting to match the listed brake hydraulic setup. The grey finish and rust preventative coating support long-term service in demanding undercar conditions.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Use 99P00918B when replacing a worn or sticking front right caliper on the listed Accord and CL models.

Common Problems This Part Addresses

• Uneven front brake pad wear on the right side
• Brake drag caused by a sticking caliper piston or slide
• Brake fluid seepage at the bleeder or inlet connection
• Corrosion-related caliper seizure on older Honda and Acura brake systems
• Poor brake pedal response from a failing hydraulic caliper assembly

Installation Notes and Tips

Verify the vehicle’s front right brake configuration before installation, especially on 1990-1993 Honda Accord models with Akebono design. Confirm the banjo bolt connection, inlet thread size, and bracket style against the removed caliper. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit.

Check rotor condition, slide movement, and hose condition during service to help ensure even braking performance. The included bleeder screw should be used during system bleeding, and copper crush washers should be installed where applicable.

Quality Assurance

Nugeon TechShield 360 (tm) calipers are remanufactured brake hydraulics built with corrosion-resistant finishing and service-specific hardware details for the listed applications. Part number 99P00918B is specified for direct fitment on select 1990-1993 Honda Accord, 1993-1997 Honda Accord, and 1997-1999 Acura CL front right brake positions.