Nugeon 99P00929A Disc Brake Caliper - Front Left or Front Right

Nugeon TechShield 360 Disc Brake Caliper

Nugeon TechShield 360 (tm) disc brake caliper Part Number 99P00929A is a remanufactured front brake caliper built for specific Honda Civic, Honda Insight, and Acura EL applications. It features a cast iron housing, grey rust-preventative finish, a single 54 mm steel piston, and included bracket, slides, dust boots, and bleeder screw for a direct-fit brake hydraulics replacement.

TechShield 360 (tm) is Nugeon’s protection-focused product line for brake hydraulics, combining remanufactured core construction with corrosion-resistant finishing and application-specific hardware details. For drivers searching for a front left or front right brake caliper for Honda Civic or Honda Insight models, Part Number 99P00929A matches the listed OE-style mounting and inlet specifications.

Key Features

• Remanufactured disc brake caliper for brake hydraulics service
• Cast iron housing with rust preventative finish
• Grey caliper finish for a clean OE-style appearance
• Single 54 mm steel piston
• Bracket included for listed applications
• Caliper slides, dust boots, hardware, and bleeder screw included
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• Bleeder screw thread: M10-1.0 x 33

Detailed Description

This Nugeon brake caliper is engineered for front axle applications that require a 2-inch, 54 mm single-piston disc brake caliper with a bracketed mounting design. It uses a cast iron body for strength and a steel piston for consistent hydraulic operation, while the rust preventative finish helps protect the caliper housing in everyday driving conditions. Part Number 99P00929A is listed for 2010-2014 Honda Insight front left, 2006-2011 Honda Civic front left, 1996-2000 Honda Civic front left, 2001-2005 Honda Civic front right, and 1997-2000 Acura EL front left applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Caliper Helps Address

• Uneven braking caused by a sticking or seized caliper piston
• Brake drag from worn internal seals or damaged dust boots
• Brake fluid leakage at the caliper body or bleeder area
• Corrosion on the caliper housing or slide components
• Poor pad movement from worn caliper slides or bracket wear

Installation Notes and Tips

Verify the vehicle position before ordering: this caliper is listed for front left and front right applications depending on year and model. Confirm the banjo bolt inlet, M10-1.0 inlet thread size, and bleeder screw thread size match the original brake line and hydraulic connection. Brake pad installation hardware and copper crush washers are included where applicable, but pads are not included.

For Honda Civic and Honda Insight brake repairs, compare the original caliper bracket style, piston size, and mounting points before installation. Always bleed the brake system after replacement and inspect the opposite side for wear patterns.

Quality Assurance

Nugeon TechShield 360 (tm) focuses on remanufactured brake hydraulics with corrosion-conscious finishing and application-specific fitment details. Part Number 99P00929A is built to match the listed vehicle applications and brake connection specifications for a direct replacement workflow.